RASHTRIYA ISPAT NIGAM LIMITED, VISAKHAPATNAM STEEL ...

More documents

Recommendations

Info

Proposal No 345061240100 Work Desc : Cond No 1a 1b 1c 1d 1e 2a 2b 2c 2d 2e 2f 2g 2h SCOPE OF WORK TENDER NO : 72265 Repair/Replacement of Steam Exhauster Duct in CCD during Capital/Major Repairs. Cond Desc Dismantling of damaged duct Fabrication of bends etc Erecting and alignment of duct welding of duct Painting of duct as per the following specifications. 1. Two coats of alluminium paint(out side only 2. Two coats of black bituminous paint(inside only) Prefabrication of bends Full painting of duct as per the specification mentioned at No 1e above Preparation of scaffoldings and plat forms at different heights Dismantling of duct and shifting to the ground level. Preparation and fixing special lifting tackles,winchs etc. Lifting of duct to different elevations above 13 mt level. Welding of joints Fixing and welding of supports. SMS/72265-0 TS Page 14 of 18 SIGNATURE OF THE TENDERER
WORK DESC : Cond No 1 2 3 4 5 6 7 8 9 TERMS AND CONDITIONS TENDER NO : 72265 PROPOSAL NO : 345061240100 Repair/Replacement of Steam Exhauster Duct in CCD during Capital/Major Repairs. SMS/72265-0 TS Cond Desc The contractor should visit the site study the job,understand the criticality,assess the requirement of the resources and safety measures. The contractor should deploy qualified work men with proper safety induction to work at heights and follow all safety procedures The contractor should have experience in executing the jobs at heights The required lifting tackles, winches etc. for erection at different heights and elevation are to be arranged by the agency. All landing platforms, scaffoldings, etc. required at heights to be made by the contractors only. These are to be dismantled and disposed after the job is over. Continuous qualified supervision is to be arranged by the contractor. The contractors will be asked to discontinue the job and the contract will be terminated if: 1. There is any lapse in the safety measures. 2. Lack of resources (men, material). 3. Lack of supervision. SALES TAX CLAUSE: a) Materials to be supplied by VSP : Spares required for the job,Structural steel,pipes and valves,duct pipes, b)Consumables to be supplied by VSP : Welding electrodes including special electrodes,gases c)Materials to be supplied by Contractor :PAINTS FOR STEAM EXHAUSTER DUCT d) Consumables to be suppliedby Contractor : NIL THE DEDUCTION OF SALES TAX SHALL BE DONE AS PER THE RULES PREVAILING FROM TIME TO TIME. Safety clause: The contractor shall ensure usage of ISI marked regulators,hoses,cutting torches,welding holders and cables for cutting and welding works. This must be adhere to strictly. Page 15 of 18 SIGNATURE OF THE TENDERER
Page 1 and 2: FORM’C’ RASHTRIYA ISPAT NIGAM L
Page 3 and 4: SMS/72265-0 TS found tampered/alter
Page 5 and 6: INSTRUCTIONS TO TENDERERS 1.a) Tend
Page 7 and 8: SMS/72265-0 TS 10. a) Total amount
Page 9 and 10: 34. Contractor shall note that: i)
Page 11 and 12: 41. The following deductions per wo
Page 13: 43. CLAUSES CONCERNING CENVAT AGAIN
Page 17 and 18: REPORT ID: RASHTRIYA ISPAT NIGAM LI

RASHTRIYA ISPAT NIGAM LIMITED, VISAKHAPATNAM STEEL ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?