2001 DVS Fireplace - Woodman's Parts Plus

PAGE 26 FINALIZING THE INSTALLATION (CONT.) - For Qualified Installers Only!
4 Install the face following the instructions included with the face.
Lopi Discovery and
Avalon Avanti Faces
Remove the screws
and lock ties used to
hold the door in place.
5/16" Nutdriver
The door and backing plate
(Discovery only) hang on the
pegs built onto the face.
�������
�������
�������
�������
�������
�������
�������
�������
�������
Phillips
Screwdriver
FPX Faces
NOTE:
See the
instructions
included
with the face
for
installation
details and
warnings.
Use the face
brackets
included with
the face.
5/16" Nutdriver
GOLD SURFACES:
After installation, remove any tape and clean gold surfaces with denatured
alcohol and a soft cloth. Fingerprints or other marks left on the gold may etch
into the gold once the fireplace reaches operating temperature.
5 Turn on gas to the heater. Leak test all gas joints prior to starting the appliance. Start the pilot. Start
the main burner. Leak test all gas joints again.
6 Check the pilot flame to make sure it looks like the illustration below. Adjust the pilot flame if
necessary.
To adjust the pilot flame,
remove the cover screw
and gasket and turn the
needle valve (NOTE: if
the needle valve is totally
unscrewed, gas will come
out of this port).
Clockwise lowers the
flame while counterclockwise
raises it.
Replace the cover screw
and gasket.
T
ON
O
Cover Screw Gasket
Standard
Screwdriver
L
PI
PILOT ADJ
OFF
��
Needle Valve
Micro (1/16”)
Standard
Screwdriver
Cover Screw
The pilot flame must contact the thermocouple and
thermopile (see the illustration below). Adjust the pilot up or
down as necessary.