2001 DVS Fireplace - Woodman's Parts Plus

PAGE 40 OPTIONAL EQUIPMENT (CONTINUED)
9 Remove the regulator from the front of the gas control valve. Replace with the propane regulator,
using the new gasket and screws included with the regulator. NOTE: Leak test this area after the
heater is installed, gas is connected, and the main burner is lit.
Align the regulator
gasket so it is flat
and the two tabs fit
through the two
holes on the
gasket.
T
ON
O
L
PI
OFF
PILOT ADJ
NOTE: These holes strip
easily. Use a hand
screwdriver and tighten
each screw evenly.
VENT
HI
LO
Regulator Gasket
NOTE: use the new gasket
included with the regulator.
These screws hold the
regulator in place.
NOTE: use the new
screws included with
the regulator.
Phillips
Screwdriver
LP (propane) regulators have a
11.0 2.8 stamped here.
10 Place the included propane label over the natural gas label on top of the gas control valve.
THIS CONTROL
HAS BEEN
CONVERTED TO
LP
11 Make the gas line connection, start the heater and thoroughly leak-test all gas connections
and the regulator. Check the pilot. Adjust if necessary.
To adjust the pilot flame,
remove the cover screw
and gasket and turn the
needle valve (NOTE: if
the needle valve is totally
unscrewed, gas will come
out of this port).
Clockwise lowers the
flame while counterclockwise
raises it.
Replace the cover screw
and gasket.
T
ON
O
Cover Screw Gasket
Standard
Screwdriver
L
PI
PILOT ADJ
OFF
��
Needle Valve
Micro (1/16”)
Standard
Screwdriver
Cover Screw
The pilot flame must contact the thermocouple and
thermopile (see the illustration below). Adjust the pilot up or
down as necessary.
VENT
HI
LO