Datascope Passport - Mindray

Operation (5-Lead, 5L, LT and XG) Controls, Indicators and Connectors (XG)
Front Panel (Continued)
SET UP CENTRAL ECG IBP NIBP ALARMS TRENDS
BEEP
SELECT ADMIT LEAD ZERO 1 START
VOLUME DISPLAY VOLUME
EXIT DISCHARGE SIZE ZERO 2 INTERVAL
LIMITS
HOLD 3 SEC. TO CLEAR
PRINT
SILENCE FREEZE CO2 PUMP DEFLATE
HOLD 3 SEC. TO STOP
15
14 13
13. START (NIBP)
A single action key which initiates an NIBP measurement. This function is not available if a
measurement is in progress.
14. INTERVAL (NIBP)
A repeat action key which selects the interval setting for NIBP measurements. Values wrap
around at the lowest/highest choices. Choices are: Off, Continuous, 1, 2.5, 5, 10, 15, 20,
30, 60, and 120 minutes. Five seconds after the selection is made and the key is released,
the new interval takes effect.
15. DEFLATE (NIBP)
A single action key which stops any NIBP measurement in progress, including any timed
measurement sequence, and deflates the cuff. When a timed measurement is stopped an
“NIBP: DEFLATE” message followed by an “NIBP: IDLE” message displays in the NIBP
message window until the timer mode is restarted by either pressing START or changing the
interval.
16. VOLUME (Alarms and Alarm LED)
A repeat action key which adjusts the alarm volume in 5 steps. There is no off position for this
tone. The tone wraps to the minimum volume once the maximum is reached. The red alarm
bell LED illuminates when an alarm condition exists. See “Alarms” on page 1-149 for
detailed information on alarm situations.
17. LIMITS (Alarms)
A single action key which provides access to the alarm menu to view and select alarm
values. Press SELECT to change the alarm values. Press the LIMITS key again to access
additional alarm parameters (when the Gas Module is installed). To return the display to the
main screen, press the EXIT key.
Passport 5-Lead, 5L, LT, XG Service Manual 0070-00-0420 1 - 83
16
18
17
R
+ -MUTE