LABRADOR - Ceccato Car Wash Equipment

1.12 CONNECTIONS
Instructions for use and maintenance LABRADOR
Water supply line to be provided:
R1 2”
Inlet water connection: minimum R 1”
Wash water pressure: min. 4 - max 6 bar
Compressed air inlet connection: R 1/2”
Air pressure: 6 bar
Attention
Any type of work on the electrical system, even when
only of a slight entity, must be carried out by professionally
qualified persons using adequate instruments
and tools.
S t a n d a r d v o l t a g e a n d f r e q u e n c y :
400 ± 10% V 50 Hz
Power supply cable:
5 x 16 mmq (400 V)
Maximum absorbed power
2 bay unit 13.4 kW
3 bay unit 18 kW
4 bay unit 20,6 kW
5 bay unit 24.2 kW
6 bay unit 27,8 kW
Note: The maximum absorbed power is measured
with all machine components in operation, i.e. bay
lighting, token suction motors, compressor , separation
tank pumps, high pressure pumps, osmotic water
pump, softened water pump, water heater.
1.12.1 INLET WATER QUALITY
The regular performance of the washing plant is
granted only if the feeding water complies with the
following characteristics:
PH 6-8 6-8
Hardness (°F) < 30 < 50
TDS salt content
(mg/l) < 3000 < 1500
total
Turbidity max (NTU) 1 1
Free chlorine (mg/l) - < 0.1
Iron < 2 < 0.05
If the water characteristics are not as espected, CEC-
CATO SpA is however at your disposal to define and
supply the most suitable treatment system to obtain
the required water quality.
1.13 OTHER FEATURES
Washing section
Water consumption, each bay:
11 litres/minute
Max gun nozzle delivery:
11 litres/minute
Temperature of the water at the nozzle:
• approx. 12 °C with feeding from aqueduct/well.
• approx. 45 °C with feeding from the heating system
Pressure of the water at the nozzle:
approx. 10 MP a (100 bar)
Water heating section
Heat generator thermal power:
from 25 to 92 kW depending on the type of boiler.
Granted hot water delivery:
from 833-2554 l/h depending on the type of boiler.
Maximum water exit temperature:
55 °C.
Maximum water exit pressure:
0,6 MP a (6 bar).
13