LABRADOR - Ceccato Car Wash Equipment

5.3 IDLE PERIODS
If the washing unit is not going to be used over a long
period of time:
1. Fill the chemical product reservoirs with water
only and allow the system to make a few complete
washing cycles. Now proceed with a few washing
simulations with the chemical product reservoirs
completely empty. These operationswill clean and
then empty the chemical dispensing and delivery
system.
2. Empty all the water pipes in the system by opening
the relevant drain cocks.
3. Disconnect the electric line that connects the
washing system to the power mains by means
of the isolator switch installed on the supply side
of the line itself. Disconnect the water and compressed
air connections. Make sure that the line
switch is not turned on again by unauthorized
persons during the period in which the system is
not used.
4. Generally grease the system using water-repellent
grease.
5. Store the spray guns and brushes in a protected
position, sheltered from direct sunlight.
32
WARNING!
Contact the Technical After Sale Service of CECCA-
TO SpA to start again the installation.
Instructions for use and maintenance LABRADOR
5.4 DISMANTLING THE UNIT
Whenever your decide to dismantle the equipment,
it must be disassebled and divided into similar units
which will be disposed of in accordance with current
local regulations concerning special waste disposal.
Lubricants and detergents of any kind must be disposed
of in accordance to their own structure.
5.5 FAULT FINDING
•
•
•
ATTENTION
Power off the equipment before carrying out any
repair or maintenance operation.
Ensure that the door locking main switch is not
actuated by unqualified or untrained personnel.
If the fault persists even after the instructions
listed hereafter have been followed, contact the
Manufacturer Technical Service.
ATTENTION
The repairs and maintenance operations with the
symbol at the side must be carried out by after sale
engineers of CECCATO SpA.