LABRADOR - Ceccato Car Wash Equipment

In addition:
•
•
Instructions for use and maintenance LABRADOR
excessive air leads to a mixture of air and foam
being delivered which results in light cracking
noises;
avoid excessive shampoo as it will make rinsing
difficult and, as a consequence, imperfect drying
and a mat finish on the vehicle.
4.2.5 USE OF THE MACHINE
1) Position the vehicle in the center of the wash
bay.
2) Obtain tokens and/or coins from the money changer.
3) Insert the tokens and/or coins into the coin box.
4) Pick up the spray gun.
5) Press the Washing button.
6) A throttled jet of water will spray from the gun.
Press the gun trigger to obtain a full jet.
7) Proceed with the other operations in sequence.
8) Consult the manager if you have problems.
Note: when switching from one wash phase to the
next, you must wait a few seconds before the
chemical product in the program you require is
delivered.
Above instruction are also affixed near the control
panels of the system.
Furthermore:
• make sure that there are no bystanders and/or
animals in the vicinity of the system as they could
be accidentally hit by the jet of water and/or by
other objects such as stones, soil, sand, etc.,
thrown up by the jet of water itself;
• the system will cease to operate once the time
allowed by the tokens/coins used has elapsed.
You must insert extra tokens or coins if you have
not finished washing the vehicle;
• once the vehicle has been washed, put the spray
gun back into its holder in the relevant wash
bay;
• the customers must press immediately the emergency
STOP pushbutton installed on the control
panel of the relevant wash bay by break-down or
malfunction of the unit or in a situation of danger.
He should then immediately inform the personnel
of the site or leave a message if the station is
unattended.
•
•
•
Depending on the type of fault, disconnect the
wash bay or the entire system from the power
supply and the water mains. Do not attempt to
repair or tamper with the system. Contact qualified
personnel.
Repairs may only be carried out by the manufacturer’s
personnel or by an authorized after-sales
service center using genuine spare parts.
WHEN PRESSING THE EMERGENCY STOP BUT-
TON, THE WASH TIME WIL BE SET TO ZERO.
Depending on the type of fault, disconnect the relevant
wash bay or the complete installation from the
electric, water and air supplies. Do not try to repair
the fault yourself, call qualified personnel.
Repairs must be carried out by the manufacturer’s
after sale service, using original spare parts.
4.2.6 WASH TIME ALLOWED BY TOKEN
OR COIN
A basic wash time unit (example 60 seconds) is provided
by each token or coin. This time can then be
drecreased with different speed, depending on the
wash phase. This setting will be done by modifying
the parameters through the programming device
connected to the PLC of the installation (see relevant
manual section).
4.2.7 DISPLAY OF AVAILABLE WASH
TIME UNIS
The display shows the total available wash time depending
on the number of tokens or coins inserted (
example: if 3 tokens are introduced, the display will
show 3x60= “180”).
The time will start to decrease when a washing program
button is pressed.
4.2.8 CHANGE OF WASH PROGRAM WHEN
THE BAY IS IN OPERATION
The programs can be changed by the customer at
any moment by pressing the relevantprogram button.
The system will stop when the available time has
elapsed.
25