LABRADOR - Ceccato Car Wash Equipment

4.2.9 OPERATION OF THE TOKEN SUC-
TION SYSTEM
When introducing a token/coint into the coin box, the
suction ssytem wil automatically start and remain on
for a time depending on the distance of the bay from
the collection safe.
4.2.10 LIGHTING
One lamp close to the control panel is automatically
switched on by a dim light switch. Complete wash bay
lighting will be switched on by token/coin inserition
and will remain on for a pre-set time after the wash
time has elapsed.
4.3 EMERGENCY STOP
26
DANGER
Press one of the emergency buttons installed in the
machine if the washing system must be stopped
immediately for any reason.
4.3.1 STOP OF INDIVIDUAL WASH BAY
The control panel of each wash bay is equipped with
a STOP button. By pressing the button, the wash
program is stopped and the wash time is set to zero.
Insert a new token/coin to start again the wash bay.
4.3.2 TOTAL EMERGENCY STOP
The whole system can be completely stopped by an
emergency.
This is done by pressing the mushroom-shaped emergency
button installed on the main electric panel that
can be released by manual rotation, or by using the
remote emergency button with key-operated release.
The remote button is normally installed closed to the
technical room, enclosed in a box with glas cover ,
and can be activated only after breaking the glas.
4.3.3 RESET OF THE INSTALLATION AF-
TER A TOTAL EMERGENCYI STOP
Washing operation can be started again after an
emergency stop only if the problem that caused the
emergency stop has been solved;
Instructions for use and maintenance LABRADOR
- Release the mechanical block of the emergency
stop push-button, by rotating the same push-button.
4.4 RESET OF OVERLOAD RELAY IN
THE ELECTRICAL CABINET
Automatic and circuit breaker switches are installed
in the general electric panel of the equipment.
ATTENTION
Before opening the electric cabinet, power off the
circuit breaker-differential switch positioned upstream
from the electric line supplying the washing
equipment (the electric system provided at the user’s
expenses, must be compulsory fitted with such a device
in compliance with the European electric safety
regulations).
Make sure that nobody can operate the circuit
breaker-differential switch during the intervention in
the lectric cabinet.
4.5 FROST PROTECTION SYSTEM
The antifreezing system is automatically activated
by the thermal probe measuring the external temperature.
This probe starts the frost protection system of the
external water pipes immediately when the temperature
drops below the selected temperature.
To avoid bilding-up of ice the external canalizations,
an electrovalve is opened and allows a continuous
small water flow through the pipes.
The regulation of the thermostat is generally set in
order to activate the system by a temperature of
approx. 2°C .
If a regulation on site is necessary to meet the local
conditions, call the after sale service.
An electric heater, installed inside the technical box,
automatically activated, has the function to protect
from freezing the components fitted in the cabinet.
The thermostat adjustment allows to regulate the
temperature in the technical box.
Note
The frost protection system operates only when the
washing unit is powered and allows to wash vehicles
with temperatures close to 0°C, (minimum temperature
-2°C).