C166/ST10 Cross-Assembler, Linker/Locator, Utilities ... - Tasking

H−30
L166 ERRORS
Appendix H
E 404: vector table scaling number is not supported
The linker / locator does not support this scaling factor. This can be
caused by an assembler that does support a larger range or an invalid
scaling factor was provided through a control.
E 405: inline vectors should be inside section C166_INT
The linker / locator demands that all inline vectors are gathered in
section C166_INT. A vector was found that was declared inline, but not
inside section C166_INT.
E 406: symbol type invalid for DPP assignment
When using symbol names to assign DPP values, the symbol type must
be a valid address or constant type.
E 407: class ’class’ not found
A class was specified using a predefined variable like
?CLASS_name_TOP or ?CLASS_name_BOTTOM. This class was not
found by the locator so the variable cannot be resolved.
E 408: symbol ’symbol’: external multiply defined with type mismatch
The external symbol symbol is defined with different types. Make sure
that the types are equal.
E 409: symbol ’symbol’: external/public type mismatch
A symbol was resolved with a mismatch between the type of the public
definition and the external declaration in another module. Make sure
that both types are equal.
E 410: symbol ’symbol’: external/global type mismatch
A symbol was resolved with a mismatch between the type of the global
definition and the external declaration in another module. Make sure
that both types are equal.