Register and win! - Megaobrabiarki

Turning on the Appliance Place the unit securely on a firm surface. Insert the mains plug into a socket. Rotate the selector switch to steam level selectionrange from the OFF position.Display - heater blinks green.Note: If there is no or not enough water inthe steam boiler, the water pump starts andsupplies water from the reservoir into thesteam boiler. The filling process may takeseveral minutes. Wait until the heater display lights uppermanently.The steam cleaner is ready to use.Note: The appliance briefly closes thevalve every 60 seconds. This will preventthe valve from sticking. There will be aslight audible click. The steam delivery isnot impaired by this.Refilling WaterIn case of water shortage, the water shortagedisplay lights up red and a signal canbe heard.Note: Every time there is not enough waterin the steam boiler, the pump automaticallysupplies water from the water reservoir intothe steam boiler. If the water reservoir isempty, the water pump is not able to fill thesteam boiler and the steam tapping isblocked. Fill the water reservoir up to the "MAX"marking.Note: The water pump tries to fill the steamboiler in short intervals. If the filling is successful,the steam tapping is released immediately,and the red display goes out.Adjusting the Steam QuantityThe emerging steam is regulated by a selectorswitch. Depending on the type ofcontamination and its severity, this selectorswitch offers adjustment possiblities fromthe minimum steam level (slight contamination)to the max. steam level (severe contamination).For severe contamination located in difficultto access areas, there is the vapohydrofunction.Adjusting the steam quantity Set selector switch to the requiredsteam volume. While operating the steam switch, alwaysdirect the steam gun at a separatepiece of cloth until the steam is emittedevenly.Turning Off the Appliance Rotate the switch to the OFF position toturn off the appliance. Disconnect the mains plug from thesocket. Press the cover of the appliance connectorto the bottom and disconnect the steamplug from the appliance connector. Empty the residual water from the waterreservoir.Storing the ApplianceIllustration - Store the round brush in the accessorycompartment. Insert the manual nozzle onto each extensionpipe. Put the extension pipes into the largeacessory holders. Insert the point stream nozzle into theaccessory storage compartment. Hook the floor nozzle into the parkingposition. Wrap the steam hose around the extensionpipes and insert the steam pistolinto the floor nozzle. Stow away the mains cable in the accessoryholder for the mains cable.20 EN – 9