ENFRIADORA AIRE/AGUA EF COMPACTA - Ferromar

ENGLISHHigh and low pressure switches should be installed in the cooling circuit and verify the refrigerantcharge (Refrigerant Charge section).To stop the equipment, disconnect switch on / off.16. PREVENTIVE MAINTENANCE• A record should be kept of each element repaired or substituted as well as of all maintenanceand repairs.• DISCONNECT THE EQUIPMENT FROM THE POWER SUPPLY before performing anymaintenance procedures.• The surface of the exterior panels may be cleaned with a soft cloth and non-abrasive cleaner.• The machine has been designed to work outdoors or indoors.• It is important to place the equipment on a stable and protected from flooding location.WARNING: in the case that the equipment will be shutdown for a long period of time, werecommend you remove the equipment or periodically ventilate the area where the equipment islocated. This is because the humid and often corrosive (chlorinated) areas where the equipment islocated may lead to premature deterioration of the electrical components. The warranty does notcover damage due to prolonged exposure to humid and corrosive atmospheres.Aspects to consider:CONDENSER BATTERY:The units should be kept clean and free of obstacles which may hinder the circulation of airthrough them. In order to clean them, use water (no pressure) and non-abrasive detergents orcleaning liquids made specifically for them (consult the manufacturer).COMPRESSOR:Oil level must be checked on compressor models that include oil viewer.Ensure that the Compressor casing resistance does work properly.EVAPORATION UNIT:Install the chemical doser at the exit of the equipment, as far as possible and under the exit level.Never on the inlet of the equipment pump, thus would damage the evaporator unit.Do not set concentrated chemical products in the skimmers that could attack the Titanium includein the condenser.In cold weathers where froze is usual, it is necessary to purge all the cleaning and heatingelements. In order to do that, the condenser includes a plug to purge it.FAN:Verify the flows of the fan each year.Clean the louvers of the fan as well as the protection grill regularly.© TALLERES DEL AGUA S.L. 2008. TODOS LOS DERECHOS RESERVADOS. DOCUMENTO CONFIDENCIAL Y EN PROPIEDAD.Page 43 of 50