1 - Hunter Fan

More documents

Recommendations

Info

D13D1421Pull wires through strain relief.Attach existing ducting to duct connector. Tape joints.If ducting does not fit securely,an adapter may need to be purchased.D15EScrew pre-loaded screws into joist or framing.D16Ground<strong>Fan</strong> MotorNight LightLight2 Pin3 PinBlackWhiteWhiteRed Night LightBlack Light*OptionGreenABlackRedBare CopperMain Switch 1 (AC In)WhiteSwitch 1 (AC In)*Option <strong>Fan</strong> & Main Light TogetherBlackSwitch 2 (AC In)Connect wires as shown.1641722-01 09/09/2011
D17D1821G•FInstall the wiring cover plate. Make sure allwiring connections are inside the box or underthe wiring cover plate.Tighten the wiring cover plate screw.D19D20HHConnect wiring from the motor to the wiring cover plate.Reinstall the motor by inserting the tabs and pushing up intoposition. Make sure the wires are not pinched between themotor and the housing.D21D22ISecure the motor by tightening the 2 screws.Turn on the power source.1741722-01 09/09/2011
Page 1 and 2: EllipseBath Ventilator with Light a
Page 3 and 4: Check all the parts.If damaged, cal
Page 6 and 7: A13Pull wires through the strain re
Page 8 and 9: A23Go to stepE1on page 18to attach
Page 10 and 11: B20FB2121G•FInstall the wiring co
Page 12 and 13: C12E9”9.75”DCut out an opening
Page 14 and 15: C22GroundFan MotorNight LightLight2
Page 18 and 19: D23OND24Go to stepE1OFFon page 18to
Page 20 and 21: WarrantyHunter Fan CompanyBath Exha
Page 22 and 23: A D V E R T E N C I APARA REDUCIR E
Page 24 and 25: 34HERetire el motor/soplador del al
Page 26 and 27: A13Tienda los cables a través del
Page 28 and 29: A23Vaya al pasoE1en la página 38 p
Page 30 and 31: B20FB2121G•FInstale la placa de c
Page 32 and 33: C12E9”9.75”DRecorte una abertur
Page 34 and 35: C22Motor del ventiladorLuz denocheL
Page 36 and 37: D13D1421Tienda los cables a través
Page 38 and 39: D23ENCENDIDOAPAGADOD24Vaya al pasoE
Page 40: GarantíaHunter Fan CompanyExtracto

1 - Hunter Fan

Create successful ePaper yourself

Delete template?

Save as template?