Flexel® 3D LevMix System for Drum
Flexel® 3D LevMix System for Drum
Flexel® 3D LevMix System for Drum
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
7. Dolly – Tank Assembly<br />
A. The Dolly has a pre-cut hole over the<br />
drive port. Insert the Interface into this hole<br />
from below and apply the O-ring as shown<br />
to secure. It is not necessary to remove<br />
or replace the Interface after mixing or<br />
between batches.<br />
B. Position the plastic tank on the dolly. The<br />
bottom surface of the tank has two pre-cut<br />
holes: a small hole <strong>for</strong> the Flexel ® <strong>3D</strong> <strong>LevMix</strong><br />
Bags <strong>for</strong> drums drain and a larger hole <strong>for</strong><br />
the drive head. Line up the larger hole with<br />
the hole in the dolly over the drive port.<br />
The larger whole should fit loosely around<br />
the Interface.<br />
C. The schematic beside indicates the<br />
different tank positions when installed<br />
on dolly LT-DBMC034.<br />
10<br />
Dolly DBMC034 top view