dB - Operator's Manual - John Deere

MAINTENANCE 33
EN
If this is not sufficient to achieve an even cut, please contact your Dealer for the adjustment
of the alignment of the cutting deck.
6.4.2 Replacing wheels
Stop the machine on flat ground and put a block under
a load-bearing part of the frame on the side that the
wheel is to be changed.
The wheels are held by a snap ring (1) which can be
eased off with a screwdriver.
NOTE If you have to replace one or both
rear wheels, make sure that any differences in their
external diameter does not exceed 8-10 mm; on the contrary, to prevent an uneven
cut it will be necessary to adjust the alignment of the cutting deck.
IMPORTANT Before remounting the wheel, apply grease to the axle. Put the
snap ring (1) and supporting washer (2) back in place.
6.4.3 Changing and repairing tyres
Tyres are of the «Tubeless» type and therefore all puncture repairs will have to be carried
out by a tyre-repair expert in accordance with the methods for this kind of tyres.
6.4.4 Replacing a fuse
2 1
The machine is fitted with fuses (1) with different capacities and functions. Specifically: