Ventilmagnet nach Valve solenoids according to ... - Duncan Rogers

16 InstallationBosch Rexroth2 Installation2.1 AssemblyPlease take care when removing the packaging thatno contaminants end up in the system.Before assembling the system check that there is nocontamination in the pipings or the valve housing.Pay attention that the O ring on the flange is notdamaged when installing the system.Allow enough room for the mimimum distancecorresponding to the temperature classes wheninstalling the valve solenoid on a wall (batteryassembly) (see technical data).☞- All installation positions are permitted, but aposition with the magnet system at the top ispreferable.- Solenoid coils can be offset and stoppedat 90°.- Tightening torque for the mounting nut:Metal nut 0.8 +/-0.12 NmPlastic nut 0.5 +/-0.075 NmClosed plastic nut 1.2 +0.2 Nm2.2 Electrical connectionConnection cable has been designed for screw/clamp connections.Please pay attention when screwing in theconnection strands that all of the wire ends arecompletely in the connection clamp.To avoid short circuits and disruptions, do not bendthe connection cable and strands.