#55166 TK 2400 ECO - Steiner Shopping GmbH

Inspections and Maintenance
Unplug the unit before any works on it.
• Use a damp cloth to clean plastic parts. Do not use detergents, solvents and pointed things either.
• Clean any dirt from the bench surface with a suitable curing compound spray.
• If the engine braking time is more than 10 s, the fast wearable parts of the engine brake may be replaced by the manufacturer or
an appropriate workshop only.
• Remove the dust stuck in the vent and on movable parts with a soft brush after every use.
• Oil all the movable metal parts regularly.
Saw Disc Replacement
Caution! Switch the unit off and unplug before any maintenance, adjustment or replacement of the saw disc.
• Turn the disc height readjusting wheel (Fig. 1/pos. 9) as far as to the upper stop .
• Remove the disc protection cover (Fig. 2/pos. 1) .
• Remove the bench removable part .
• Take the splitting wedge out (Fig. 2/pos. 17).
• Use a spanner to hold the spindle .
• Use another spanner to loosen the disc screw . Turn anticlockwise (clockwise thread) .
• Now, turn the height adjusting wheel (Fig. 2/pos. 9) as far as to the lower stop so that the disc
may be taken out easily. .
• Put the disc from the hub and lift it up
• Before putting in a new or sharpened disc, clean the hub carefully .
• Putting in and securing a new disc should be done in reverse order.
• Notice! Mind the correct direction of turning! The teeth cutting edge should point in the direction of
rotation i.e. forward. Mind the arrows on the disc and the protection cover !
• Put back and straighten the splitting wedge (Fig. 2/pos. 17) and protection cover t (Fig. 2/pos. 1) .
• Before using the saw again make sure that all the safety and protection devices work correctly.
• Important! If you put on the disc again, turn it a little by hand and check to see that it turns freely. .
• Afterwards, connect the unit and before using it, let it idle at first. .
Fig. 18
Driving belt replacement
Open the bench liner, remove the splitting wedge n (Fig. 2/pos. 18) and exhaust hose (Fig. 2/pos. 15) and put the unit head up on the
bench. .
• Loosen the disc screw with wrench 24 anticlockwise while
holding the disc spindle with wrench 13.
Fig. 19
• Remove the saw disc .
Fig. 20
• Put the screwdriver behind the flat belt .
Fig. 21
29