Commander SK - Control Techniques

3-polige klemmenstrook
Klem Functie
1 Netwerk data line A
2 Netwerk data line B
3 Scherm
Parameters
Para- Beschrijving Fabr. Para- Beschrijving Fabr.
meter
inst meter
inst
15.01 Module ID code 401 15.30 Load option defaults OFF
15.02 Firmware version 15.31 Save option parameters OFF
15.03 Node address 0 15.32 Request to re-initialise OFF
15.06 Diagnostics: messages per second 0 15.33 Restore parameters from option module OFF
15.07 Network loss trip 0 15.34 Initialise drive reference selectors OFF
15.10 Subnet ID 15.35 Option module serial number -
15.11 Domain ID length 0 15.36 Transmit service pin message OFF
15.12 Domain ID byte 1 0 15.37 Winl active OFF
15.13 Domain ID byte 2 0 15.38 Unconfigure option module 0
15.14 Domain ID byte 3 0 15.39 Default configuration property storage 0
15.15 Domain ID byte 4 0
15.16 Domain ID byte 5 0 15.50 SM-LON error codes 0
15.17 Domain ID byte 6 0 15.51 Minor firmware version
Error codes
De errorcode is weergegeven in #15.50
Kleur:
Zacht groen
SK menu 15
SM-LON optiemodule
Errorcode
Fout Beschrijving
0 Geen fout gedetecteerd Indicatie dat de trip niet werd veroorzaakt door SM-LON, mogelijk via externe
communicatie kanalen.
58 Incorect non-volatile storage At least one configuration property was incorrectly formatted or corrupt.
Configuration property defaults are downloaded
61 Invalid configuration parameters This trip will occur if the SM-LON option module is installed in a Unidrive SP
configured in regen mode
65 Network loss
70 No valid fieldbus data available No valid fieldbus data available in the module to download to the drive. The
user may not have saved any data or the data save may not have completed
successfully
74 Overtemperatuur in de optiemodule Temperatuur in de optiemodule > 82 °C, Commander SK geeft trip 74
99 Interne software fout
SK handleiding, versie 7 pagina 138 van 154
SM-Optiemodule frontaanzicht
Dipschakelaar
out
in
1 2 3
A B S
2 stuks 56 Ohm
ballast weerstanden
W
S
Wink LED
Service LED