CoolMatic CRF-50 - Waeco

Safety instructions
CoolMatic CRF-50
✓ This symbol describes the result of an action.
fig. 2 1, page 3: This refers to an element in an illustration. In this case,
“item 1 in figure fig. 2 on page 3”.
Please also observe the following safety instructions.
2 Safety instructions
Attention!
WAECO International will not be held liable for claims for damage
resulting from the following:
• Damage to the device resulting from mechanical influences and
excess voltage
• Alterations to the device made without the explicit permission of
WAECO International
• Use for purposes other than those described in the operating
manual
2.1 General safety
• Have a trained technician perform the installation in wet rooms.
• Do not operate the appliance if it is visibly damaged.
• This appliance may only be repaired by qualified personnel. Inadequate
repairs can cause considerable hazards.
If you device should need repairing, please contact WAECO
customer service.
• Do not open the refrigerant circuit under any circumstances.
• Set up the appliance in a dry location where it is protected
against splashing water.
• Do not place it near naked flames or other heat sources (heaters,
direct sunlight, gas ovens etc.).
• Ensure that the ventilation slots are not covered.
• The appliance is not suitable for the storage of caustic materials
or materials containing solvents.
• For use only on vessels over 20 meters in lenght.
22