CoolMatic CRF-50 - Waeco
CoolMatic CRF-50 - Waeco
CoolMatic CRF-50 - Waeco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>CoolMatic</strong> <strong>CRF</strong>-<strong>50</strong><br />
Troubleshooting<br />
11 Troubleshooting<br />
Compressor does not run<br />
Fault Possible cause Remedy<br />
U KL = 0 V<br />
There is an interruption in the connection<br />
between the battery and the<br />
electronics<br />
Establish a connection<br />
Main switch faulty (if installed) Replace the main switch<br />
Additional supply line fuse has blown<br />
(if installed)<br />
Replace the supply line<br />
fuse<br />
U KL ≤ U ON Battery voltage is too low Charge the battery<br />
Start attempt with<br />
U KL ≤ U OFF<br />
Loose cables<br />
Poor contact (corrosion)<br />
Establish a connection<br />
Battery capacity too low<br />
Cable cross section too small<br />
Start attempt with Ambient temperature too high –<br />
U KL ≥ U ON<br />
Electric circuit between<br />
the pins in the compressor<br />
interrupted<br />
Usage when the ambient<br />
temperature is too<br />
low<br />
Insufficient ventilation and/or air<br />
supply<br />
Condenser is dirty<br />
Fan defective (if installed)<br />
Defective compressor<br />
The compressor only starts up at an<br />
ambient temperature of more than<br />
+16 °C.<br />
Replacing the battery<br />
Replace the cable<br />
(fig. 8, page 6)<br />
Move the freezer to<br />
another location<br />
Clean the condenser<br />
Replace the fan<br />
Replace the compressor<br />
Only switch on the freezer<br />
at an ambient temperature<br />
of more than +16 °C.<br />
U KL<br />
U ON<br />
U OFF<br />
Voltage between the positive and negative terminals of the electronics<br />
Cut-in voltage of the electronics<br />
Cut-off voltage of the electronics<br />
Interior temperature too low in control level “1”<br />
Fault Possible cause Remedy<br />
Compressor runs constantly<br />
Compressor runs for a<br />
long time<br />
Thermostat sensor has no contact on<br />
the vaporiser<br />
Faulty thermostat<br />
Large quantities have been frozen in<br />
the freezer compartment<br />
Secure the sensor<br />
Change the thermostat<br />
–<br />
33