You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
FIRST INSTALLATION<br />
Adjust the band to the closest sole mark and lock it by<br />
closing the lever in the centre position.<br />
Then you can hook the band into the heel and into the toe<br />
– there is only one position possible.<br />
pict 33<br />
Now hook the brake into the heel housing.<br />
pict 34<br />
Then you can slide the binding on the RAILFLEX base<br />
from the rear until the mark on the band cover is aligned<br />
with the selected mark on the center piece (+15/0/-15).<br />
Make sure that all components of the binding are engaged<br />
with the base. Then fix the binding position by tightening<br />
the screw in the center piece.<br />
pict 35<br />
pict 36<br />
32 / MOUNTING<br />
Finally put a boot into the binding and check the forward<br />
pressure. If you followed each step correctly, the indicator<br />
should rest in the marked area.<br />
pict 37<br />
If you have too much or not enough forward pressure,<br />
open the lever in the centre with a slotted screwdriver<br />
and check the settings. If necessary, adjust slightly at the<br />
heel and the toe. Then close the lever and check the<br />
forward pressure again. Now it should be okay.<br />
Once the binding is mounted onto a ski it is very easy to<br />
adjust it to another boot sole length. Just open the lever<br />
in the center and slide toe and heel to the desired centimeter<br />
mark.<br />
pict 38<br />
OK<br />
Finally close the lever and check forward pressure as<br />
described before.<br />
RAILFLEX SYSTEM II - DEMO<br />
Make sure that the boot is satisfying the international<br />
standards and has no functional damage.<br />
Hook the brake into the heel housing as shown in pict 39.<br />
pict 39<br />
Connect toe and heel with the Railflex Demo Band by<br />
snapping the metal pins of the toe in the band (pict 40).