You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
DRILL TEMPLATE RACEPLATE RDX<br />
1. Compatibility<br />
Presently the drill template RACEPLATE RDX can be used<br />
for:<br />
HEAD<br />
RACEPLATE RDX<br />
TYROLIA<br />
RACEPLATE RDX<br />
Drill template RACEPLATE RDX is for mounting of RACE-<br />
PLATE RDX. It can be used for ski widths from 59 to 108<br />
mm. For other skis use the template adapter set (art. no.<br />
162 569). With this adapter set skis from 45 to 132 mm<br />
can be mounted.<br />
2. POSITIONING THE DRILL<br />
TEMPLATE<br />
Open the clamping jaws (2) by rotating the clamping<br />
handles (1) and then place the template on the ski. Align<br />
the boot midsole indicator (3) with the midsole mounting<br />
mark on the ski. Be sure the template is evenly seated<br />
against the ski’s top surface. Release clamping handles.<br />
pict 55<br />
NOTE: Keep in mind that some ski manufacturers do not<br />
use the center of boot sole location method. Always<br />
follow the ski manufacturer’s instructions.<br />
3. DRILLING THE HOLES<br />
If not otherwise specified by the ski manufacturer use a<br />
4.1 Ø x 9.0 mm drill bit for skis 140 cm and longer.<br />
DRILL THROUGH THE APPROPRIATE BUSHINGS:<br />
Boot sole length Color of indicator<br />
260 - 320 mm gold<br />
290 - 350 mm silver<br />
36 / MOUNTING<br />
After drilling place a drop of TYROLIA glue into the holes.<br />
It lubricates the screws and seals the holes (pict 56).<br />
pict 56<br />
4. MOUNTING - plate<br />
Place a washer on the outer outside holes and tighten the<br />
screws (4x).<br />
pict 57<br />
Place a washer also on the outer center hole.<br />
pict 58<br />
Art. No. 162 866
Change language