Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Problem Possible Reason Solution<br />
SYMPRO toe<br />
wobbles<br />
in this track<br />
CYBER or FREE FLEXdrill<br />
pattern<br />
not fitting<br />
Heel slides<br />
backwards when<br />
customer steps in<br />
Binding fails<br />
pre-season test:<br />
release values too<br />
high or too low<br />
Adult bootsole<br />
does not fit into<br />
Junior toe lug<br />
Diagonal or<br />
Railflex heel<br />
wobbles in the track<br />
68 / SERVICE<br />
Toe locking lever not properly Remove toe, clean track.<br />
engaged in locking holes Be sure toe piece locks into place<br />
Toe / equalizing bridge Dismount, place toe<br />
in wrong position in correct position<br />
Drill template Readjust,<br />
not locked drill new holes<br />
Rear locking lever not fully closed Lever should fully engage locking<br />
or boot length exceeds teeth in slots on track or boot sole<br />
adjustment range length exceeds binding range<br />
Clean or replace boot as<br />
Reference boot indicated by<br />
contaminated or worn clean vs. lube<br />
test result<br />
Forward pressure Readjust to TYROLIA<br />
set incorrectly recommendations<br />
Incorrect or Check the template. Remount<br />
off-center-mounting using template correctly<br />
Improper use of Check calibration and<br />
testing device operating technique<br />
Boot sole exceeds<br />
the standard tolerance<br />
Heel glide inserts worn<br />
Clean AFD and boot sole,<br />
check standard tolerance,<br />
change boot<br />
Remove heel and<br />
replace plastic heel guides