Bedienungsanleitung AstroTec-868 - Friedrich-schroeder.de

Explanation of functionsPRIORITY (factory setting priority = OFF, only visible in expertmode)If the priority is switched to “ON“, the clock has a higher priority andoverrides the manual-automatic sliding switch setting of the hand-heldtransmitter programmed in the receiver.Clock commands are executed even if the manual-automatic slidingswitch of the hand-held transmitter programmed in the receiver is setto ““.If the manual-automatic clock sliding switch is set to ““, no clockcommands will be executed.If the priority is “OFF”, clock commands are only executed when themanual-automatic sliding switch of the hand-held transmitter programmedin the receiver is set to “”.SHADING (factory setting shading = OFF, onlyvisible in expert mode)If shading is switched to “ON“ the automatic shading system isswitched off with the ““ clock command.The automatic shading system is switched on by the „“ clockcommand.PREREQUISITE!The manual-automatic selection switch of the programmedtransmitter has to be set to „“.As long as the manual-automatic sliding switch of the programmedtransmitter is set to ““ , the automatic shading is always switched offand is not affected by the timer.If shading is switched to “OFF“, then the automatic shading system isnot influenced by the clock.EN-18