CNC 8037 - Installation manual - Fagor Automation

Installation manual
Connector X5 - For electronic handwheel connection
15-pin high density SUB-D type female connector.
Pin Signal and function
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
A1
/A1
B1
/B1
A2
/A2
B2
/B2
+5 V
+5 V
GND
GND
100P
- - -
Chassis
Feedback signals of first handwheel.
Feedback signals of second handwheel.
Supply output.
Supply output.
Supply output.
Supply output.
Push button of Fagor 100P handwheel.
Shield
It admits differential (double-ended) and non-differential (single-ended) TTL feedback.
The cable must have overall shielding. The rest of the specifications depend on the feedback system
used and the cable length required.
The cable shield must be connected to the metallic hood at each end.
It is highly recommended to run these cables as far as possible from the power cables of the machine.
When using a FAGOR 100P model handwheel, connect it as first handwheel and connect the axis
selecting signal (button) to pin 13.
1.
CNC CONFIGURATION
CNC structure
CNC 8037
SOFT: V01.4X
·35·