INTELLINET Gigabit SATA NAS - PCDeacitec

1.2 model 505895 / 3 tb
1.2.1 System requirements
• Computer with Internet browser and network access for setup
• Switch or router with one free Ethernet port for the NAS
• One or two 3.5” SATA-I or SATA-II hard drives (1.5 Gbps) with 20 GB – 1.5 TB per
drive (3 TB total)
• For RAID 0 and 1, two hard drives of identical capacity are recommended
1.2.2 front Panel
The buttons and jacks on
the front panel are detailed
below from top to bottom.
Power switch — Press to
turn the unit on or off; On
will display a blue light.
NOTE: It takes about a
minute for the system to
boot once the unit is on.
LED status indicators — The
OS (operating system) LED on the left lights green to indicate the system is on/
ready; blinks to indicate the system is starting or is shutting down; and remains
off to indicate the system has shut down. The HDD (activity) LED on the right
lights amber to indicate an error (disk not found or a RAID error); blinks to
indicate data access; and remains off to indicate there is no disk activity.
USB backup button — Press and hold in for 4 seconds to back up your files.
USB device port — This USB type-A port is for connection to an external USB hard
drive, USB flash drive or USB printer.
1.2.3 rear Panel
The buttons and jacks on
the rear panel are detailed
below from top to bottom,
left to right.
Security lock slot — Lock is
not included.
Ventilation fan— The black
jumper at J4/J5 can be
re-positioned to set the
mode for the fan speed.
6
hardware