Maintenance for the Avaya G250 and Avaya G350 ... - Avaya Support

G250/G350 component maintenance
Table 8: G350-001# set sync interface primary v4
G350-001# show sync timing
SOURCE MM STATUS FAILURE
Primary V4 Locked Out None
Secondary Not Configured
Local V0 Active None
Comment: No failures, Sig is green and ACT On 2700 ms off 300 ms
Note that the MM710 in slot 4 has been declared to be the primary sync source
but it is not active until the next command is sent.
Table 9: G350-001# set sync source primary
G350-001# show sync timing
SOURCE MM STATUS FAILURE
Primary V4 Active None
Secondary Not Configured
Local V0 Standby None
Comment: The ACT LED does not change its behavior.
Note:
Note: The following command is sent from the SAT CLI, and not from the G350 CLI.
To test for slippage, from the SAT, use the command:
test mo logical 4255 physical 1v4 test 144
The results from the above command are shown in Table 10: TEST RESULTS on page 38:
Table 10: TEST RESULTS
Port Maintenance
Name
Alt. Name Test No.
Result
001V4 MG-DS1 144 PASS
Command successfully completed
38 Maintenance for the Avaya G250 and Avaya G350 Media Gateways
Error Code