OPERATORS MANUAL - Westerbeke

More documents

Recommendations

Info

Starting Battery Battery Capacity DC Charging Alternator Starter Starting Aid DC No-Load Cu rrent DC Cranking Current General- Single Phase Voltage - Single Phase Voltage regulation: Frequency regulation: Rating (Volts AC) SPECIFICATIONS WESTERBEKE 25 KW BEDA GENERATOR ELECTRICAL SYSTEM AC GENERATOR (3 Phase) 12-Volt. (-) negative ground 400 - 600 Cold Cranking Amps (CCA) 51 Amp rated, belt-driven 12-Volt, Reduction Gear Glow plugs, sheathed type ± 2% of rated Amps 250 - 300 Amps (engine cold) AC GENERATOR (SINGLE PHASE) Brushless, four-pole, revolving field Sealed lubricated single bearing design. Reconnectable single phase for 120/240 volts with solid state voltage regulator. 120 or 120/240 Volts - 60 Hertz 220 Volts - 50 Hertz ± 2% no load to full load. .3 Hertz no load to tuilioad. 20 I
Engine Type Aspiration Governor Combustion Chamber Bore & Stroke Piston Displacement Firing Order Direction of Rotation Maximum Torque (at 1800 rpm) Compression Ratio Dimensions Weight SPECIFICATIONS WESTERBEKE 32 KW BEDA GENERATOR SPECIFICATIONS Diesel, four-cycle, four-cylinder, fresh water-cooled, Vertical, in-line overhead valve mechanism (46 hp at 1800 rpm maximum). Naturally aspirated. Electronic Governing Swirl type 3.94 x 4.33 inches (100.1 x 110.0 mm) 210.8 cubic inches (3.5 liters) 1 - 3 - 4 - 2 Clockwise, when viewed from the front 1661b-ft (23 kg-m) 18:1 Height: Width: Length: 30.0 inches 22.0 inches 44.6 inches 10381bs (471.8 kgs) TUNE·UP SPECIFICATIONS Compression Pressure 427 psi (30 kg/eml) at 200 rpm (limit of difference between cylinde,,) 47.2 psi (3.0 kg/cm'l) Valve Timing Engine liming Injector Pressure Valve Seat Angle Valve Clearance (engine cold) Engine Speed Intake Opens 19" BTDC Intake Closes 47° ABDC Exhaust Opens 52" BBDC Exhaust Closes 14' ATDC Static timed - drop valve method 0.180 ± .005 inches BTDC 2450 ± 35 psi (1 + 5-0 kg/cm') Intake 45" Exhaust 30° (762.0 mm) (558.8 mm) (113.3 mm) Intake 0.012 inches (0.3 mm) Exhausl 0.014 inches (0.35 mm) 1800 RPM 60 Hertz 1500 RPM 50 Hertz General Fuel Fuellnjeclion Pump Fuellnjeclion Timing Nozzle Fuel Filter (on engine) Air cleaner Air Flow (engine combustion) General Operating Temperature Fresh Water Pump Raw Water Pump Raw Water Flow, at 1800 rpm System Capacity (fresh water) General Oil Filler Sump CapaCity (not including filter) Operating Oil Pressure (engine hot) 0,1 Grade Engines & Generators 47 FUEL SYSTEM Open flow, self priming - 1 bleed point No.2 diesel oil (cetane rating of 45 or higher) ZEXEL Model PE (In-Line) 12" BTDC Orifice type Full Flow Replaceable Metal screen type - cleanable 110 cfm (3.1 cmm) COOLING SYSTEM Fresh water-cooled block, thermostaticallycontrolled with heat exchanger. 170 -190" F (77 - 88" C) Centrifugal type, metal impeller, belt-driven Positive displacement, rubber impeller, belt driven. 15.0 gpm (567 Ipm) (measured before discharging into exhaust elbow). 8.5 qts (8.04 lite,,) LUBRICATION SYSTEM Pressure led system Full flow, paper element, spin-on type 6.3 U.S. qts (6.0 liters) plus filter/cooler assembly 50-60 pSi (3.5 - 4.2 kg/cm') API Specification of CF or CG-4, SAE 30, lOW-3D, 15W-40
Page 4: ACCIDENTAL STARTING A WARNING: Acci
Page 7: OPERATORS MANUAL WESTERBEKE MARINE
Page 11: SERIAL NUMBER LOCATION The engine a
Page 15: THE STARTING SYSTEM Westerbeke dies
Page 18 and 19: CHECK LIST Follow this check list e
Page 20: MAINTENANCE SCHEDULE NOTE: Use the
Page 23: GASKET Changing the Raw Water Pump
Page 38 and 39: If the pressure is different from t
Page 49: General Many owners rely on their b
Page 52: Starting Battery Battery Capacity D
Page 60: COMPONENT Cylinder head bolts Cylin

OPERATORS MANUAL - Westerbeke

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?