PDT 3100 Series Product Reference Guide

Downloading Over the Network: DHCP
Spectrum24® RF Setup
To use the DHCP protocol, you must edit NET.CFG and rebuild the HEX file before initiating
the network connection.
1. Edit NET.CFG (see Editing NET.CFG on page 3-5). Add the section header and
DHCP parameter line:
Spectrum24 Control
DHCP
2. Save the new NET.CFG on the network host in the \LWPnnn\KIT directory.
3. Working from the \LWPnnn\KIT directory, rebuild the HEX file. Use the
command:
USRCFG @LWPNFL
which builds a LWPNFL.HEX file in the KIT subdirectory.
4. Download the new HEX file. Refer to the Series 3000 ADK.
5. Proceed with the network connection as described in Initiating Network Connection
on page 3-7.
Downloading Over the Network: Neither BOOTP or DHCP
If a BOOTP or DHCP server is not used, the information these servers provide must be
obtained in other ways (e.g., you must enter the IP address manually using CFG24).
1. Edit NET.CFG (refer to Editing NET.CFG on page 3-5). Add a control section and
noboot parameter:
Spectrum24 control
Noboot
2. Save the NET.CFG file, build and download a new HEX file, and connect to the
network as described in Downloading Over the Network: DHCP on page 3-11.
3-11