600 RUSH 800 RUSH - Polaris
600 RUSH 800 RUSH - Polaris
600 RUSH 800 RUSH - Polaris
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
FEATURES<br />
Fuel Resistor<br />
This snowmobile is equipped with a feature that allows the engine controller<br />
to select the proper operating software based on the type of fuel<br />
being used. See pages 65-66 for fuel information and recommendations.<br />
The ECU fuel designation connector must have the “NON-ETHANOL<br />
160 OHM” resistor installed when using non-ethanol gasoline.<br />
When using ethanol, MTBE, or other forms of oxygenated gasoline, the<br />
“10% ETHANOL 24 OHM” resistor must be connected.<br />
Whenever in doubt of your fuel purchase, use the “10% ETHANOL 24<br />
OHM” resistor as a safeguard.<br />
The resistor is installed into the wiring harness on the left side of the<br />
snowmobile just above the top of the oil bottle (see photo).<br />
NOTICE: Engine damage may occur if ethanol fuel is used while the non-ethanol<br />
fuel resistor is installed. The check engine light may also display in<br />
this condition as this could cause detonation.<br />
10% ETHANOL<br />
24 OHM<br />
NON-ETHANOL<br />
160 OHM<br />
ETHANOL, MTBE, OR OTHER<br />
OXYGENATED GASOLINE<br />
(Factory Delivery)<br />
ANY FUEL WITH ETHANOL<br />
or LESS THAN 91 OCTANE<br />
(87 Octane Minimum)<br />
NON-ETHANOL GASOLINE<br />
91+ OCTANE<br />
(Maximum Performance)<br />
Resistor<br />
27