93619 Distance Measure - Harbor Freight Tools
93619 Distance Measure - Harbor Freight Tools
93619 Distance Measure - Harbor Freight Tools
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Operation<br />
This tool will quickly and accurately measure distances. It will accumulate several<br />
measurements in memory, and will perform area and volume computations.<br />
In addition to distance measurements, area computations have many uses including<br />
estimating wall covering or paint requirements, room sizes, etc. Volume computations<br />
are useful in planning HVAC, heating and cooling requirements, etc.<br />
<strong>Measure</strong>ments are made using an ultrasonic beam which is targeted with a laser<br />
beam. The laser beam will help you see the measurement which is actually made<br />
with an invisible ultrasonic beam.<br />
Since local conditions, such as temperature, vibration, humidity, etc. may affect the<br />
measurement, you can take several dynamic readings to determine the most<br />
accurate distance.<br />
For the following instructions, please refer to the diagrams on page 4 to<br />
identify components and displays.<br />
<strong>Distance</strong> <strong>Measure</strong>ment:<br />
1. Point the Ultrasonic Sensor Aperture (1) in the direction of the distance to be measured.<br />
2. Press the READ Key (10) to start the tool. NOTE that the laser light will<br />
indicate the place measured. Press the READ Key (10) several times to<br />
determine an accurate reading. The measured distance will be displayed on<br />
the upper line of the Display Screen.<br />
3. By pressing the FT/M Key (6), you can alternate the reading between SAE<br />
and Metric readings.<br />
NOTES:<br />
A. The measured object must not be blocked by any barriers.<br />
B. For precise results, use a large smooth surface for measurements.<br />
C. If the measured surface is soft or irregular, you may place a hard item,<br />
such as a piece of board in front to provide an accurate reflective surface.<br />
D. <strong>Measure</strong>ments cannot be made through glass.<br />
E. The measured distance should be greater than 2 feet and less than 50’.<br />
F. The measured distance is from the bottom of the tool (reference point 11,<br />
page 4).<br />
To Add Sequential <strong>Measure</strong>ments without using Memory:<br />
1. Press the READ Key (10) to make a measurement. The measured value is<br />
shown in the top line of the display.<br />
2. Press the +/= Key (9) to enter the addition mode. The “+” icon (A) will appear<br />
in the Display Screen. The measurement will be repeated in the lower line in<br />
the Display Screen. You may press the +/= Key (9) to cancel this operation.<br />
SKU <strong>93619</strong> For technical questions please call 1-800-444-3353. Page 5