Samsung iPOLiS SRN-3250 User Manual - Use-IP

Caution
Note
If the product specifications are not followed by the user, some data can
be lost. So be sure to configure the camera settings in consideration of
the limit of the product specifications. (Refer to Product Specifications)
If you change the camera settings while in record mode, the image
recorded at the moment of the change may not be played properly.
The NVR can be used in connection with Samsung Techwin network products as
well as with AXIS products. AXIS cameras have, however, limited compatibility
with this product, as described below.
Only AXIS cameras that support both VAPIX and MPEG4 output are
compatible with this product.
Audio Encoding: G711 μ-law
Camera Search: Cannot search.
Resolution: In Camera Setup page, one of D1, Half D1, or CIF can be selected
as a AXIS resolution. But certain AXIS camera models do not support D1, Half
D1, and CIF resolutions. In this case, please use the following chart to
determine Video Mode and Video Resolution. For instance, if you want to use
CIF video resolution for an AXIS camera, check if 352x240, 320x240, or
352x288 is listed under the resolution in the chart. If one of the sizes is
available, that means that you can use the resolution. If a selected resolution
is not applicable, the product searches for a supported resolution in the order
of D1, Half D1, and CIF, and then changes the resolution automatically. AXIS
cameras that do not support any of the listed resolutions below cannot be
used in connection with the NVR.
NTSC PAL
D1 704x480, 4CIF, 640x480 704x576
Half D1 704x240, 2CIF 704x288
CIF 352x240, 320x240 352x288
50