Samsung iPOLiS SRN-3250 User Manual - Use-IP
Samsung iPOLiS SRN-3250 User Manual - Use-IP
Samsung iPOLiS SRN-3250 User Manual - Use-IP
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Rebooting system<br />
is in Progress...<br />
For more information about the default settings value, please refer to "2.3. Default Settings"<br />
Note<br />
5.1.6. HDD Check<br />
The Factory Reset does not reset the RAID settings of the system or delete data<br />
saved in the HDDs.<br />
Under System, select 6. Test HDD, then press Enter. The following messages appear asking<br />
you to select an HDD to check.<br />
HDD to examine<br />
Internal HDD? [1]<br />
HDD to examine<br />
RAID PARTITION? [1]<br />
Selecting an HDD displays a message asking if you really want to perform disk-checking for<br />
the selected HDD.<br />
Record on this HDD<br />
will be stopped<br />
Are you sure?<br />
Yes: Enter No: Esc<br />
When pressing ENTER, the following message appears as the disk-checking process is<br />
initiated. Once the process is complete, the screen displays the check results.<br />
Executing...<br />
Please Wait!!!<br />
Examining Int HDD[1]<br />
is in Progress...<br />
Examining Int HDD[1]<br />
[DONE]<br />
HDD test result:<br />
0 bad block<br />
The check results stay on the screen until you click a button.<br />
When selecting an HDD that is not available or connected, the following message appears.<br />
80