INCREMENTAL ENCODER MyInc - MEYER Industrie-Electronic ...

30
INCREMENTAL ENCODER MyInc
Mounting advice:
1
Cyl.-pin to DIN 7 ø 4 mm
ORDERING CODE
BINH37
Flange
1 = Hollow shaft
with short
torque stop
2 = Hollow shaft
with long
torque stop
5 = Hollow shaft
with stator
coupling
1) Do not connect the encoder and drive
rigidly to one another at the shaft and
flange!
2) To mount a hollow shaft encoder, we
recommend the use of a pin and with
torque stop slot or a stator coupling.
Meyer Industrie-Electronic GmbH – MEYLE
Carl-Bosch-Straße 8
49525 Lengerich/Germany
Tel.: +49 54 81-93 85-0
Fax: +49 54 81-93 85-12
BINH37
3) When mounting the encoder ensure
that Lmin. is greater than the axial play
of the drive.
When using the long torque stop, a
greater axial play is possible.
Max. permissible drive shaft impact:
(measuring error ≤ ± 0,5 bit and 4 times evaluate in the sequential electronic).
Shaft Ø
Mounting with stator coupling Mounting with
torque support
Pulses: Permissible axial Permissible radial Permissible radial
impact impact impact
up to 1024: ±0.4 mm ±0.09 mm ±0.075 mm
1 = Ø 4 mm
2 = Ø 5 mm
3 = Ø 6 mm
4 = Ø 1/4“
6 = Ø 8 mm
Output circuit and Supply
voltage
A2 = RS 422: 5 V DC ±5
%
A5 = Push-pull (with
inverted signals)
5 ... 30 V DC
Connection
3A = Cable* radial
(1 m PVC-cable)
3R = Cable* radial
(2 m PVC-cable)
* “Tube Tech ® ” cable outlet guarantees 10 x higher strain relief than
traditional cabling methods plus higher IP-Protection.
Other cable lengths available on request.
Internet: www.meyle.de
E-Mail: sales@meyle.de
Resolution
1024 max.