Print MSDS - Miller Electric Company Publications
Print MSDS - Miller Electric Company Publications
Print MSDS - Miller Electric Company Publications
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Suitable extinguishing media:<br />
Specific hazards:<br />
Unusual hazards:<br />
Specific methods:<br />
The product is not flammable. Extinguish fire using agent suitable for surrounding fire.<br />
Not applicable<br />
None known<br />
No special methods required<br />
Special protective equipment for firefighters: As in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH<br />
(approved or equivalent) and full protective gear<br />
Extinguishing media which must not be used for safety reasons: No information available<br />
Personal precautions:<br />
Environmental precautions<br />
and clean-up methods:<br />
6. ACCIDENTAL RELEASE MEASURES<br />
Not relevant for the product itself.<br />
Clean-up methods - large spillage. Absorb spill with inert material (e.g. dry sand or earth), then place in<br />
a chemical waste container. Use a water rinse for final clean-up.<br />
7. HANDLING AND STORAGE<br />
Handling:<br />
Avoid contact with skin and eyes. FOR COMMERCIAL AND INDUSTRIAL USE ONLY.<br />
Storage:<br />
Protect from freezing. Keep tightly closed in a dry, cool and well-ventilated place. KEEP OUT OF REACH OF CHILDREN.<br />
Engineering measures to reduce exposure:<br />
No special ventilation requirements General room ventilation is adequate<br />
8. EXPOSURE CONTROLS / PERSONAL PROTECTION<br />
Personal Protective Equipment<br />
Eye protection: No special requirements under normal use conditions.<br />
Hand protection: No special requirements under normal use conditions<br />
Skin and body protection: No special requirements under normal use conditions.<br />
Respiratory protection: No special requirements under normal use conditions.<br />
Hygiene measures: Handle in accordance with good industrial hygiene and safety practice.<br />
Ingredient(s) CAS # ACGIH OSHA Mexico<br />
2-butoxyethanol 111-76-2 20 ppm (TWA) Skin 50 ppm (TWA) 240<br />
mg/m 3 (TWA)<br />
Monoethanolamine 141-43-5 6 ppm (STEL) 3 ppm (TWA) 3 ppm (TWA) 6 mg/m 3<br />
(TWA)<br />
Physical State: Liquid<br />
Appearance: Aqueous solution<br />
Specific gravity: 1.01<br />
Vapor density: No information available<br />
Boiling point/range: Not determined<br />
Decomposition temperature: Not determined<br />
Solubility: Completely Soluble<br />
Solubility in other solvents: No information available<br />
Partition coefficient (n-octanol/water): No information available<br />
Elemental Phosphorus: 0.00 % by wt.<br />
pH: 11.3<br />
Explosion limits: - upper: Not determined - lower: Not determined<br />
5. FIRE-FIGHTING MEASURES<br />
9. PHYSICAL AND CHEMICAL PROPERTIES<br />
Bulk density: No information available<br />
Evaporation Rate No information available<br />
Color: Clear Red<br />
Odor: Fresh Pine<br />
Melting point/range: Not determined<br />
Autoignition temperature: No information available<br />
Density: 8.42 lbs/gal 1.01 Kg/L<br />
Flash point: > 200 °F > 93.4 °C<br />
Viscosity:No information available<br />
VOC: 2 % *<br />
Dilution pH: 11.3 @ RTU<br />
* - Title 17, California Code of Regulations, Division 3, Chapter 1, Subchapter 8.5, Article 2, Consumer Products, Sections 94508<br />
Spitfire RTU Power Cleaner<br />
10. STABILITY AND REACTIVITY<br />
75 ppm (STEL) 360 mg/m3 (STEL) 26 ppm (TWA) 120<br />
mg/m3 (TWA)<br />
6 ppm (STEL) 15 mg/m3 (STEL) 3 ppm (TWA) 8<br />
mg/m3 (TWA)<br />
2 of 4
Change language