Print MSDS - Miller Electric Company Publications

DR
Material Safety Data Sheet
acc. to ISO/DIS 11014
Page 3/10
Printing date 01/29/2009 Reviewed on 01/29/2009
Trade name: ACID CORE
3 Composition/Data on components
(Contd. of page 2)
Chemical characterization
Description: Mixture of the substances listed below with nonhazardous additions.
Dangerous components:
7440-31-5 tin 0-100%
7439-92-1 lead
0-100%
Danger: 3.1.O/3, 3.1.I/4
~
Warning: 3.7/2 ~
7440-50-8 copper 0-100%
7440-36-0 antimony 0-100%
7440-69-9 bismuth 0-100%
7440-22-4 silver 0-100%
7440-66-6 zinc 0-100%
7646-85-7 zinc chloride
Danger: ~ 3.1.O/3; ~ 3.2/1B
Warning: ~ 4.1.C/1
142-04-1 anilinium chloride
Danger: ~ 3.1.O/3, 3.1.D/3, 3.1.I/3, 3.4.S/1; ~ 3.9/1, 3.5/2, 3.6/2; ~ 3.3/1
Warning: ~ 4.1.A/1
Additional information:
Composition and weight percent of solder alloys varies widely and can be determined by product label.
Flux in core is typically 1-3% by weight.
4 First aid measures
≤ 2.5%
≤ 2.5%
General information:
Symptoms of poisoning may even occur after several hours; therefore medical observation for at least 48 hours after
the accident.
After inhalation:
Supply fresh air. If required, provide artificial respiration. Keep patient warm. Consult doctor if symptoms persist.
After skin contact: Immediately wash with water and soap and rinse thoroughly.
After eye contact: Rinse opened eye for several minutes under running water.
After swallowing: Seek immediate medical advice.
5 Fire fighting measures
Suitable extinguishing agents:
CO2, extinguishing powder or water spray. Fight larger fires with water spray or alcohol resistant foam.
Special hazards caused by the material, its products of combustion or resulting gases:
Melted solder above 1000°F will liberate toxic lead and/or antimony fumes.
In case of fire, the following can be released:
Carbon monoxide (CO)
Carbon dioxide (CO2)
(Contd. on page 4)
USA