Humax DTT UK TUTVR User Guide 080405.qxp - Find help

More documents

Recommendations

Info

Using your Digital Box for the first time The first time you use your Humax Digital Box, you will see a screen like the one below. The Digital Box now needs to scan for available Digital TV channels. • Press [OK] on your Digital Box's remote control to begin searching for digital channels The search will take between 2 and 5 minutes, depending on the digital TV service in your area. • As channels are found, their names are listed on the TV screen. • When the scan has finished, the Digital Box will automatically switch to the first channel in the list. 10 You can now explore and enjoy the channels available on your Digital TV service. If you have a Top Up TV card, please register it before attempting to use it. Then follow the installation instructions supplied with the card. Using Standby When you are not watching TV, you should set your Digital Box to 'Standby'. To do this: • Press [POWER] to switch between ON (green light) and STANDBY (red light). If you plan to leave your Digital Box unattended for a long period, switch it off and unplug it at the mains supply. (Don’t worry - all of your settings will be saved.) Changing channels To ‘hop’ through the channels • Press [ ^ ] or [ ] on your Digital Box remote control. ^ To choose a particular channel • Press one of the buttons [0] to [9], then press [OK]. • To select 2 or 3 digit channels (10 to 999), press the number buttons required in succession, then press [OK]. • If you do not press [OK], the Box will change to the selected channel after approximately 1 second.
Using the Programme Guide Now and Next information The Programme Guide shows a full list of available channels and programmes. When you choose the Guide, the channel you are watching appears as a small inset screen. To view the Guide: • Press [GUIDE]. • Press [ ^ ] or [ ] to scroll • through the list of channels. To scroll through the programmes press []. • To scroll forwards and backwards, one day at a time, press the [blue] and the [yellow] colour buttons. • To preview the highlighted channel, press [INFO]. ^ To add a reminder to watch a particular programme, highlight the programme and press the [green] colour button. The reminder will show for a short period when the programme starts. To add the selected programme to your Timer, press the [red] colour button. • To view the highlighted channel, press [OK]. • To exit the TV Guide without changing channel, press [EXIT] or [GUIDE]. The [SWAP] button lets you easily keep an eye on two TV channels by switching between the current channel and the last channel you watched for more than 5 seconds - so you can ‘hop’ between the two channels. Please note: this feature does not operate when the TV Guide is displayed. Now and Next gives you information on the current and next programmes on each channel. • To open the Now/Next menu press [INFO]. This displays information on the programme showing Now. • To see information on the programme showing Next, press [>]. • To see more detailed information press [INFO] again. • To change the channel you want information for press [ ^ ] or [ ]. • To watch the highlighted channel press [OK]. • To exit the Now/Next menu without changing channel press [EXIT]. ^ 11
Page 1 and 2: Digital TV receiver User guide
Page 3 and 4: Index Package contents . . . . . .
Page 5 and 6: Remote control buttons Power Switch
Page 7 and 8: Setting up your Digital Box with a
Page 9: Setting up your Digital Box with no
Page 13 and 14: Timer Programming You can set the D
Page 15 and 16: Using parental controls to block ch
Page 17 and 18: Using your VCR with the Digital Box
Page 19 and 20: General problem solving What happen
Page 21 and 22: Where to get more help If you have
Page 23 and 24: Warranty Thank you for purchasing t

Humax DTT UK TUTVR User Guide 080405.qxp - Find help

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?