Vendor Routing Guide - CSI Vendor Manual

Vendor Routing Guide Lane Bryant & Catherines
8.10 Packing Cartons
8.10.1 Please Reference section 3.1 to 3.1.3 and 3.1.5 to 3.2 of the Retail Routing
Guide for packing instructions.
8.11 Polybag Specifications:
8.11.1 Important Note: It is the responsibility of the vendor to make sure that
poly bagged items pass the sag test (hold bag by the two upper corners).
If the item sags more than 1/2” from top of bag to top of item, either (1) refold
and place in smaller bag or (2) re-fold and use chipboard stiffener.
8.11.2 Minimum/Maximum polybag Item
Minimum –N/A
Maximum - All individually packaged products must be no more than
22”L x 15”W.
8.11.3 Dimensions of polybags vary depending on the bulk and folded size of the
item. Once packaged, the item should fit comfortably in the polybag (no
creases or puckers) but not move freely inside the bag (bag should be close
fitting).
8.11.4 Polybag must be high density polyethylene material and the thickness level
must be .05mm or greater.
8.11.5 Polybag warning:
A polybag large enough to fit over a child’s head means, any bag with opening
larger than 5” (flat opening) must have the following “warning” printed on with black
ink.
Warning text must be in both English and French Canadian languages.
Warning: To avoid danger of suffocation, keep this plastic bag
away from babies and children. Do not use this bag in cribs, beds,
carriages, or playpens. This bag is not a toy.
Avertissement: Pour éviter tout risque de suffocation, gardez ce
sac en plastique hors de portée des bébés et des enfants. Ne pas
utiliser ce sac dans des berceaux, lits, poussettes ou parcs pour
enfant. Ce sac n’est pas un jouet.
Version 8.0, Last Modified: 5/14/2013 Page 41 of 45