Aladin MKII Manual Ver 1.14 - Schneider Optics

More documents

Recommendations

Info

32 Details 5.2. Transceiver-Module AL-TR-400 MK II The MK II type of the transceiver module connects the receiver and the hand unit(s) by using wireless or serial wired transmission/reception. In addition, the power supply for the hand unit is switched and monitored. The MK II version extends the features of the standard module with an additional serial port socket and a graphical full color OLED display for advanced functionality. An USB socket is supplied for software updates on the fly via USB memory sticks. Auxiliary Serial Port for RS232/ RS422 - Communication USB Mini B 5 Pin Green Status LED for Power State Figure 6 - Transceiver Module MK II 5.2.1. 5 Axis Control Knob This button serves as power ON/OFF switch as well as a 5 axis navigation button for the menu operation. If unit is off, press the knob down until LEDs light up and menu appears in the display. For powering the unit down, keep this knob pressed down for more than 2 seconds, until display switches off. A short down will operate as an OK or EXIT function. Pushing the knob forward and backward will act as a selection of a menu entry while pushing it left or right will modify the selected entry (left = minus, right = plus). BNC- Socket for Antenna Multi color OLED Display Red Status LED for Connection State 5 Axis Control Knob for Menu Navigation and power ON/OFF
5.2.2. Green LED „power“ Details 33 This LED indicates the power state of the transmitter’s battery. Constantly on shows normal state while flashing means that battery state is low and unit will switch off in the next minutes. 5.2.3. Red LED „connection state“ If LED is on no connection is established neither for wireless nor for serial connection between the motor controller box (receiver) and the hand unit. 5.2.4. Auxiliary Serial Port In conjunction with special adaptor cables this socket allows wired communication to the ALADIN MKII receiver as well as to third party devices. 5.2.5. BNC Socket „antenna“ An antenna, 50 Ohm, for 434/869 MHz band is connected to this BNC-socket. In case of extremely bad reception due to i.e. broadband interferences or long distances (i.e. 300m), the connection between the transmitter and the receiver may be made through a standard BNC cable. 5.2.6. Multi color OLED Display The AL-TR xxx MKII Transmitter unit features the same OLED display as the MKII- receiver does. An OLED display has many advantages over a LCD display. I.E. the contrast ratio and the behavior at deep temperatures are much better. 5.2.7. Short menu description Transmitter Start up Screen Version: 01.00.xx ALADIN MKII SETUP (OK) Chan. 0/ 434.225 Transmitter Main Screen This screen comes up when starting the hand unit. The current software version of the transmitter unit is displayed. Press navigation knob down to enter further set up menu entries from here. Information area on the bottom of this screen informs about selected radio channel or serial connection mode. A battery gauge displays current battery level. The green rf signal indicator informs about signal strength from feedback transmissions of the receiver.
Page 1: 333
Page 4 and 5: 4 Content Table of Contents 1. Intr
Page 6 and 7: 6 Introduction
Page 8 and 9: 8 Introduction 2. Short Overview 2.
Page 10 and 11: 10 Introduction 2.3. Considerations
Page 12 and 13: 12 Details 3.1.4. Socket „ANTENNA
Page 14 and 15: 14 Details 3.3. Receiver Menu Pleas
Page 16 and 17: 16 Details M2 Setup Link To: * Mode
Page 18 and 19: 18 Details … … Config: Config:
Page 20 and 21: 20 Details are addressed by an inde
Page 22 and 23: 22 Details 3.3.13.2. Lens Data Focu
Page 24 and 25: 24 Details 3.3.13.4. Lens Data Zoom
Page 26 and 27: 26 Details 3.3.14. Matching Setup S
Page 28 and 29: 28 Details Type Type of of Extensio
Page 30 and 31: 30 Details 5. Transmitter / Hand Co
Page 34 and 35: 34 Details Set Up RF-Channel Commun
Page 36 and 37: 36 Details Turn the hand wheel coun
Page 38 and 39: 38 Details 5.5.5. Zoom Scale (LED-B
Page 40 and 41: 40 Details Example: Drive lens ring
Page 42 and 43: 42 Advanced Features To switch the
Page 44 and 45: 44 Connections 8. Connection Exampl
Page 46 and 47: 46 Connections 8.2. Remote Control
Page 48 and 49: 48 Technical 10. Technical Informat
Page 50 and 51: 50 Technical 10.2. Electronic Calib
Page 52 and 53: 52 Technical 10.3.3. Electrical Cha
Page 54 and 55: 54 Documentation 10.5. Declarations
Page 56 and 57: 56 Documentation
Page 59: Documentation 59

Aladin MKII Manual Ver 1.14 - Schneider Optics

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?