ML-4512ND Manual - OlsonBros

More documents

Recommendations

Info

Media and tray To avoid damaging the machine, use only transparencies designed for use in laser printers. • Must withstand the machine’s fusing temperature. • Place them on a flat surface after removing them from the machine. • Do not leave unused transparencies in the paper tray for long. Dust and dirt may accumulate on them, resulting in spotty printing. • To avoid smudging caused by fingerprints, handle them carefully. • To avoid fading, do not expose printed transparencies to prolonged sunlight. • Ensure that transparencies are not wrinkled, curled, or have any torn edges. • Do not use transparencies that separate from the backing sheet. 2. Menu overview and basic setup • To prevent transparencies from sticking to each other, do not let the printed sheets stack up as they are being printed out. • Recommended media: Transparency for a color laser printer by Xerox, such as 3R 91331(A4), 3R 2780 (Letter). Labels To avoid damaging the machine, use only labels designed for use in laser printers. • When selecting labels, consider the following factors: - Adhesives: Should be stable at your machine’s fusing temperature. Check your machine’s specifications to view the fusing temperature (about 170°C (338°F)). - Arrangement: Only use labels with no exposed backing between them. Labels can peel off sheets that have spaces between the labels, causing serious jams. 40
Media and tray - Curl: Must lie flat with no more than 13 mm of curl in any direction. - Condition: Do not use labels with wrinkles, bubbles, or other indications of separation. • Make sure that there is no exposed adhesive material between labels. Exposed areas can cause labels to peel off during printing, which can cause paper jams. Exposed adhesive can also cause damage to machine components. • Do not run a sheet of labels through the machine more than once. The adhesive backing is designed for only a single pass through the machine. • Do not use labels that are separating from the backing sheet or are wrinkled, bubbled, or otherwise damaged. Card stock/ Custom-sized paper 2. Menu overview and basic setup • In the software application, set margins at least 6.4 mm (0.25 inches) away from the edges of the material. 41
Page 1 and 2: User’s Guide Basic imagine the po
Page 3 and 4: Contents 5. Appendix 106 Specificat
Page 5 and 6: Key benefits Environmentally friend
Page 7 and 8: Features by models Some features an
Page 9 and 10: About this user’s guide This user
Page 11 and 12: Safety information Caution Do not r
Page 13 and 14: Safety information Do not place the
Page 15 and 16: Safety information When toner gets
Page 17 and 18: Machine overview 10 14 13 12 11 1
Page 19 and 20: Control panel overview 12 This co
Page 21 and 22: Turning on the machine 1 2 Connect
Page 23 and 24: Reinstalling the driver If the prin
Page 25 and 26: Menu overview The control panel pro
Page 27 and 28: Menu overview Network Items Options
Page 29 and 30: Menu overview Items Options Setup (
Page 31 and 32: Printing a demo page Print a demo p
Page 33 and 34: Media and tray This chapter provide
Page 35 and 36: Media and tray 6 Squeeze the paper
Page 37 and 38: Media and tray 2 3 Adjust the multi
Page 39: Media and tray To print an envelope
Page 43 and 44: Media and tray ML-5015 Series/ ML-5
Page 45 and 46: Basic printing 13 Canceling a pri
Page 47 and 48: Basic printing Using a favorite set
Page 49 and 50: Basic printing Eco options • Pri
Page 51 and 52: Using USB memory device 18 Printi
Page 53 and 54: 3. Maintenance This chapter provide
Page 55 and 56: Available supplies When supplies re
Page 57 and 58: Available accessories Accessory Fun
Page 59 and 60: Redistributing toner When the toner
Page 61 and 62: Replacing the toner cartridge Click
Page 63 and 64: Replacing the imaging unit Click th
Page 65 and 66: Upgrading a memory module The order
Page 67 and 68: Replacing the stapler cartridge The
Page 69 and 70: Setting the toner low alert If the
Page 71 and 72: Cleaning the machine 3. Maintenance
Page 73 and 74: 4. Troubleshooting This chapter giv
Page 75 and 76: Clearing paper jams 1 To avoid te
Page 77 and 78: Clearing paper jams 3 In the mult
Page 79 and 80: Clearing paper jams 4. Troubleshoot
Page 81 and 82: Clearing paper jams 5 In the exit
Page 83 and 84: Clearing paper jams 4. Troubleshoot
Page 85 and 86: Clearing paper jams 7 In the opti
Page 87 and 88: Clearing paper jams Paper jam at th
Page 89 and 90: Clearing paper jams Paper jam insid
Page 91 and 92:
Understanding the status LED The co
Page 93 and 94:
Understanding display messages Mess
Page 95 and 96:
Understanding display messages Tone
Page 97 and 98:
Understanding display messages •
Page 99 and 100:
Understanding display messages •
Page 101 and 102:
Understanding display messages Tray
Page 103 and 104:
Understanding display messages Erro
Page 105 and 106:
5. Appendix This chapter provides p
Page 107 and 108:
Specifications Power consumption It
Page 109 and 110:
Specifications Envelope Type Size D
Page 111 and 112:
Specifications 3 Type Size Dimensio
Page 113 and 114:
Specifications Linux Operating syst
Page 115 and 116:
Specifications Network operating sy
Page 117 and 118:
Regulatory information 7 8 Ozone sa
Page 119 and 120:
Regulatory information 13 Radio fre
Page 121 and 122:
Regulatory information If you cut o
Page 123 and 124:
Regulatory information 20 China onl
Page 125 and 126:
Index
Page 127 and 128:
User’s Guide Advanced imagine the
Page 129 and 130:
Contents 6. Troubleshooting 110 Pap
Page 131 and 132:
Installation for Macintosh 1 2 3 4
Page 133 and 134:
Reinstallation for Macintosh If the
Page 135 and 136:
Installation for Linux 3 4 5 1 2 3
Page 137 and 138:
2. Using a network-connected machin
Page 139 and 140:
Wired network setup You must set up
Page 141 and 142:
Wired network setup 2. Using a netw
Page 143 and 144:
Installing driver over the network
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
IPv6configuration 10 1 2 3 4 5 IP
Page 157 and 158:
IPv6configuration 13 4 5 6 1 2 3
Page 159 and 160:
Wireless network setup 2. Using a n
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Information Item Description Menu M
Page 187 and 188:
Paper Item Description Copies Selec
Page 189 and 190:
System setup Item Description Date
Page 191 and 192:
System setup Export Setting Toner S
Page 193 and 194:
Network Option Description TCP/IP (
Page 195 and 196:
Eco Item Description Eco-On You can
Page 197 and 198:
4. Special features This chapter ex
Page 199 and 200:
Changing the font setting Your mach
Page 201 and 202:
Setting your machine as a default m
Page 203 and 204:
Using advanced print features 2 Und
Page 205 and 206:
Using advanced print features Doubl
Page 207 and 208:
Using advanced print features Overl
Page 209 and 210:
Using advanced print features Print
Page 211 and 212:
Using Direct Printing Utility (Wind
Page 213 and 214:
Macintosh printing 8 Some features
Page 215 and 216:
Linux printing 13 Some features may
Page 217 and 218:
Linux printing 4 • Jobs: Shows th
Page 219 and 220:
Unix printing • Orientation: Sele
Page 221 and 222:
Storing the toner cartridge (or ima
Page 223 and 224:
Tips for moving & storing your mach
Page 225 and 226:
Useful management tools SyncThru We
Page 227 and 228:
Useful management tools 6 1 2 3 4 5
Page 229 and 230:
Useful management tools Alert Sett
Page 231 and 232:
Useful management tools Smart Panel
Page 233 and 234:
Useful management tools Printers t
Page 235 and 236:
6. Troubleshooting This chapter giv
Page 237 and 238:
Power and cable connecting problems
Page 239 and 240:
Printing problems Condition Possibl
Page 241 and 242:
Printing problems Condition Possibl
Page 243 and 244:
Printing quality problems Toner spe
Page 245 and 246:
Printing quality problems Vertical
Page 247 and 248:
Printing quality problems Wrinkles
Page 249 and 250:
Printing quality problems Curl If t
Page 251 and 252:
Operating system problems 2 Common
Page 253 and 254:
Operating system problems 4 Refer t
Page 255 and 256:
Contact SAMSUNG worldwide Country/R
Page 257 and 258:
Contact SAMSUNG worldwide Country/R
Page 259 and 260:
Glossary BOOTP Bootstrap Protocol.
Page 261 and 262:
Glossary Duty Cycle Duty cycle is t
Page 263 and 264:
Glossary IP address An Internet Pro
Page 265 and 266:
Glossary MH Modified Huffman (MH) i
Page 267 and 268:
Glossary PPM Pages Per Minute (PPM)
Page 269 and 270:
Glossary Toner Cartridge A kind of
Page 271 and 272:
Index C Changing 73 D direct printi
show all

ML-4512ND Manual - OlsonBros

Create successful ePaper yourself

Delete template?

Save as template?