MODEL 2100AN LABORATORY TURBIDIMETER INSTRUMENT ...

SECTION 1, continued
1.4.2 Operating Environment
If any of the items are missing or damaged, please contact the Customer
Service Department, Hach Company, Loveland, Colorado. Do not return the
instrument without prior authorization. In the United States, the toll-free number
is 1-800-227-4224. Outside the United States, contact your nearest Hach dealer.
Use the turbidimeter in a clean, dust-free environment on a bench or table that is
free of vibration and that provides good air circulation around the instrument.
Keep the areas in the back and underneath of the instrument case free of materials
that could obstruct air flow through the vents.
1.4.3 Operating Power Selection
The instrument is completely assembled when shipped from the factory except
for connecting the power cable to the chassis receptacle on the rear panel.
Voltage selection for 115 or 230 Vac is done automatically.
A power cord suitable for U.S. and Canadian 115 Vac line voltage is supplied with
the Model 2100AN (Cat. No. 47001-00). If this model is to be configured for
230 Vac, an approved UL/CSA power cord with NEMA 6-15P type cord cap must
be used in place of the 115V power cord supplied.
The Model 2100AN (Cat. No. 47001-02) is factory configured for European
230 Vac line voltage. The power cord supplied with this model is VDE approved,
and has a Continental European type plug.
13