CodeWarrior Development Studio for Power Architecture - Freescale ...
CodeWarrior Development Studio for Power Architecture - Freescale ...
CodeWarrior Development Studio for Power Architecture - Freescale ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Configuring Target Hardware<br />
Preparing the BSC9132QDS Board<br />
3. Check the default switch positions and verify the board is operational, be<strong>for</strong>e changing the switches.<br />
The BSC9132 QDS board has dedicated switches controlling whether the StarCore and <strong>Power</strong><br />
<strong>Architecture</strong> cores are exposed as separate JTAG chains, or through a single unified chain.<br />
For a single unified JTAG chain, set the on-board dipswitch SW10[7:8] to ON/ON<br />
(CFG_JTAG_MODE_0:1 = 00). The JTAG connector will be J3 (COP HEADER).<br />
For single TAP mode through primary JTAG header (J3, COP Header), set the onboard<br />
dipswitch SW10[7:8] to ON/OFF (CFG_JTAG_MODE_0:1 = 01).<br />
For single TAP mode through secondary JTAG header (J2, ONCE Header), set the on-board<br />
dipswitch SW10[7:8] to OFF/OFF (CFG_JTAG_MODE_0:1 = 11).<br />
NOTE Refer to the BSC9132 QDS Hardware Getting Started document to learn how to specify the<br />
switches and jumper header settings.<br />
4. Assemble and connect the board.<br />
a. Ensure that all power is turned off.<br />
b. Connect 12-volt power supply, power cable, and country-specific wall plug.<br />
c. Connect the power-supply jack cable to the board power connector P4.<br />
d. Plug power supply into the surge-protected strip.<br />
18 <strong>Power</strong> <strong>Architecture</strong>® Processors Getting Started Guide
Change language