CodeWarrior Development Studio for Power Architecture - Freescale ...

More documents

Recommendations

Info

$Set of General Math and Motor Control Functions for ARM Cortex ...$

Configuring Target Hardware Preparing the BSC9132QDS Board 20 Power Architecture® Processors Getting Started Guide
Working with Projects Power Architecture® Processors Getting Started Guide 3 This chapter explains how to use the CodeWarrior IDE to create projects for boards that contain a Power Architecture processor. Launching CodeWarrior IDE Creating Projects Building Projects Debugging Projects Deleting a Project 3.1 Launching CodeWarrior IDE To launch the CodeWarrior IDE, perform these steps: 1. Select Start > Programs > Freescale CodeWarrior > CW for PA number > CodeWarrior, where number is the version number of your product. The WorkSpace Launcher dialog box appears, prompting you to select a workspace to use. NOTE Click Browse to change the default location for workspace folder. You can also select the Use this as the default and do not ask again checkbox to set default or selected path as the default location for storing all your projects. 2. Click OK. The default workspace is accepted. The CodeWarrior IDE launches and the Welcome page appears. NOTE The Welcome page appears only if the CodeWarrior IDE or the selected Workspace is opened for the first time. Otherwise, the Workbench window appears. 3. Click Go to Workbench, on the Welcome page. The workbench window appears. The CodeWarrior IDE is ready for use. You can now create, build, debug or customize your project to match your requirements. 21
Page 1 and 2: CodeWarrior Development Studio for
Page 3 and 4: Table of Contents 1 Introduction 5
Page 5 and 6: Introduction This Getting Started g
Page 7 and 8: Power Architecture® Processors Get
Page 9 and 10: Configuring Target Hardware This ch
Page 11 and 12: Figure 2.1 B4860QDS Board Power Arc
Page 13 and 14: 2.3 Preparing the P4080DS Board 1.
Page 19: Power Architecture® Processors Get
Page 29 and 30: 3.4.1 Debugging Bareboard Projects
Page 31 and 32: 7. Specify a name for the new proje
Page 33 and 34: Listing 3.2 Identifying the partiti
Page 45 and 46: 3.4.5 Debugging U-Boot To configure
Page 49: Index A Auto build mode 28 B BSC913

CodeWarrior Development Studio for Power Architecture - Freescale ...

Create successful ePaper yourself

Delete template?

Save as template?