34169621 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH

More documents

Recommendations

Info

Status display: SET = Datum setting REF = blinking: Traverse the reference points. On continuously: Reference points have been traversed. ∆ = Distance-to-go display 1 2 Datum 1 or 2 Inch = Display in inches SCL = Scaling factor ->❘❘
This manual is for the ND display units with the following software numbers or higher: ND 720 for two axes AA00 ND 760 for three axes AA00 About this manual This manual is divided into two parts: Part I: Operating Instructions Fundamentals of positioning ND functions Part II: Installation and specifications Mounting the display unit on the machine Description of operating parameters Switching inputs, switching outputs Part I Operating Instructions Fundamentals 4 Switch-On, Traversing the Reference Points 9 Datum Setting 10 Datum setting with the tool 10 Datum setting with the KT Edge Finder 13 Tool Compensation 18 Moving the Axes with Distance-To-Go 19 Bolt Hole Circles and Bolt Circle Segments 21 Linear Hole Patterns 24 Working with a Scaling Factor 27 Error Messages 28 Part II Installation and Specifications Page 29 Part I Operating Instructions 3
Page 1: User’s Manual Position Display Un
Page 5 and 6: Datum setting The workpiece drawing
Page 7 and 8: Nominal position, actual position a
Page 9 and 10: Switch-On, Traversing the Reference
Page 11 and 12: SPEC FCT SPEC FCT or PROBING ENT PR
Page 13 and 14: Datum Setting with the KT Edge Find
Page 15 and 16: X PROBE X (appears only briefly) 5
Page 17 and 18: PROBE MIDP. X ENT If required, sele
Page 19 and 20: Moving the Axes with Distance-To-Go
Page 21 and 22: Bolt Hole Circles and Bolt Circle S
Page 23 and 24: HOLE DEPTH 5 START SPEC FCT ENT ENT
Page 25 and 26: SPEC FCT LIN. HOLE ENT 1ST HOLE X 2
Page 27 and 28: Working with Scaling Factors Scalin
Page 29 and 30: Part II Installation and Specificat
Page 31 and 32: Connections on Rear Panel ID label
Page 33 and 34: Connecting the Encoders Your displa
Page 35 and 36: List of Operating Parameters P1 Uni
Page 37 and 38: P80 Function of the CL key Set to z
Page 39 and 40: Parameter settings for HEIDENHAIN l
Page 41 and 42: Multipoint Axis Error Compensation
Page 43 and 44: Deleting a compensation value table
Page 45 and 46: RS-232-C/V.24 (Option) In addition
Page 47 and 48: Measured value output when probing
Page 49 and 50: Measured value output over the cont
Page 51 and 52: Example of measured value output ov
Page 53 and 54:
Dimensions in mm/inches Tilting bas
show all

34169621 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH

Create successful ePaper yourself

Delete template?

Save as template?