34169621 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH

More documents

Recommendations

Info

Items Supplied 30 Items Supplied ND 720 for 2 axes or ND 760 for 3 axes Power connector Id. Nr. 257 811-01 User's Manual Optional Accessories Tilting base for housing bottom Id. Nr. 281 619-01 KT 130 Edge Finder Id. Nr. 283 273-01
Connections on Rear Panel ID label Power switch Power input Edge finder input RS-232-C/V.24 data interface Protective ground Encoder inputs X1 to X3 Rubber feet with M4 thread The interfaces X1, X2, X3, and X10 comply with the requirements for electrical separation according to EN 50178! Connections on Rear Panel 31
Page 1 and 2: User’s Manual Position Display Un
Page 3 and 4: This manual is for the ND display u
Page 5 and 6: Datum setting The workpiece drawing
Page 7 and 8: Nominal position, actual position a
Page 9 and 10: Switch-On, Traversing the Reference
Page 11 and 12: SPEC FCT SPEC FCT or PROBING ENT PR
Page 13 and 14: Datum Setting with the KT Edge Find
Page 15 and 16: X PROBE X (appears only briefly) 5
Page 17 and 18: PROBE MIDP. X ENT If required, sele
Page 19 and 20: Moving the Axes with Distance-To-Go
Page 21 and 22: Bolt Hole Circles and Bolt Circle S
Page 23 and 24: HOLE DEPTH 5 START SPEC FCT ENT ENT
Page 25 and 26: SPEC FCT LIN. HOLE ENT 1ST HOLE X 2
Page 27 and 28: Working with Scaling Factors Scalin
Page 29: Part II Installation and Specificat
Page 33 and 34: Connecting the Encoders Your displa
Page 35 and 36: List of Operating Parameters P1 Uni
Page 37 and 38: P80 Function of the CL key Set to z
Page 39 and 40: Parameter settings for HEIDENHAIN l
Page 41 and 42: Multipoint Axis Error Compensation
Page 43 and 44: Deleting a compensation value table
Page 45 and 46: RS-232-C/V.24 (Option) In addition
Page 47 and 48: Measured value output when probing
Page 49 and 50: Measured value output over the cont
Page 51 and 52: Example of measured value output ov
Page 53 and 54: Dimensions in mm/inches Tilting bas

34169621 - heidenhain - DR. JOHANNES HEIDENHAIN GmbH

Create successful ePaper yourself

Delete template?

Save as template?