AutoTrac Universal (ATU) - StellarSupport - John Deere

Start-up Screen
Each time a machine equipped with AutoTrac is
started, this screen appears as a reminder of operator
responsibilities when using AutoTrac steering system. To
clear this screen press I AGREE.
IMPORTANT: When starting machine with AutoTrac
installed and this start-up screen is not
displayed, update AutoTrac software through
www.StellarSupport.com.
Enabling System
Press STEER ON and OFF button to toggle between
enable and disable AutoTrac.
To enable system, all of the following criteria must be met:
• AutoTrac activation is detected.
Activating System
CAUTION: While AutoTrac is activated, operator
is responsible for steering at end of path
and collision avoidance.
Do not attempt to turn on (Activate) AutoTrac
system while transporting on a roadway.
After system has been ENABLED, operator must manually
change system to ACTIVATED status when steering
assistance is desired.
Press resume switch (A) initiating assisted steering.
In order to activate system following criteria must be met:
• Vehicle speed is greater than 0.5 km/h (0.3 mph).
• Forward vehicle speed is less than
Tractor - 30 km/h (18.6 mph)
Sprayer - 37 km/h (23 mph)
Combine - 20 km/h (12.4 mph)
• Reverse vehicle speed is less than 10 km/h (6.0 mph).
• Vehicle within 45 degrees of desired track.
• Operator is seated.
• TCM is on.
• In reverse AutoTrac remains activated for 45 seconds.
After 45 seconds, the machine must be put in a forward
gear before reverse activates again.
GS2 1800 Display
35-1
• Track 0 has been set up.
• Tracking mode selected.
• Proper operator presence mode selected.
• TCM must be installed and turned on.
• AutoTrac Controller Steering Kit is plugged in.
A—Resume Switch
PC13157 —19—17FEB11
BA31779,000023E -19-26JUL11-1/1
OUO6050,000115A -19-05JUN09-1/1
PC8700 —UN—11AUG05
OUO6050,000115B -19-05JUN09-1/1
091411
PN=30