ECX-DIO8 - esd electronics, Inc.

More documents

Recommendations

Info

Page 6 of 33 This page is intentionally left blank. Hardware Manual • Doc.-No.: E.3010.21 / Rev. 1.0 ECX-DIO8
1. Overview 1.1 Description of the Module 24V Power Connector MSTBO 2,5/4- G1L-KMGY 24V Inrail-Bus Connector X101 24V +24 V= DC/DC Converter +3.3 V= 3.3V ET1100 EtherCAT-Controller DOUT 8 DIN 8 8x Digital I/O + + - Ref + - Ref + - Ref + - Ref + - Ref + - Ref + - Ref - Ref Ethernet PHY KSZ8721 Ethernet PHY KSZ8721 Fig. 1: Block circuit diagram of the ECX-DIO8 module Overview X500 VIO ECX-DIO8 Hardware Manual • Doc.-No.: E.3010.21 / Rev. 1.0 Page 7 of 33 8 2 10 DIO Status LEDs EtherCAT IN 100BASE-TX RJ45 with LEDs EtherCAT OUT 100BASE-TX RJ45 with LEDs The ECX-DIO8 is an EtherCAT digital I/O-module. It is equipped with 8 digital I/Os, each available as input and output. The nominal I/O-voltage value is 24 V. Nominal output current is 0.5 A at 24 V. The ECX-DIO8 module provides industrial digital in-/outputs with two-wire connection in combination with service-friendly wiring of supply voltage. The power supply can be applied via the InRailBus connector (TBUS-connector) integrated in the mounting rail or separately via the clamp-connection. The 100BASE-TX EtherCAT® interface is compatible to IEEE 802.3. Configuration is done by EtherCAT® master (XML file). The module is designed for hat-rail mounting in a control enclosure. The digital I/O connectors and status LEDs are mounted in the front panel.
Page 1 and 2: ECX-DIO8 Hardware Manual • Doc.-N
Page 3 and 4: Document- File: Date of print: 2011
Page 5: Contents 1. Overview . . . . . . .
Page 9 and 10: 2.2 Digital In/Outputs Technical Da
Page 11 and 12: 3.2 LEDs 3.2.1 LEDs in the Front Pa
Page 13 and 14: 3.2.1.2 Status of the LEDs 1-8 Hard
Page 15 and 16: 3.3 Installation of the Module Usin
Page 17 and 18: Hardware Installation 3. Swivel the
Page 19 and 20: 4. Connector Assignment 4.1 Power S
Page 21 and 22: 4.3 Digital In/Outputs (X500) Pin N
Page 23 and 24: 5. Quick Start Guide ! Quick Start
Page 25 and 26: 5. Select the EtherCAT Device in th
Page 27 and 28: Software 8. The ECX-DIO8 (Box 1) is
Page 29 and 30: Outputs current output state Output
Page 31 and 32: Software OutputsOverloadError indic
Page 33: 8. Order Information ECX-DIO8 Manua

ECX-DIO8 - esd electronics, Inc.

Create successful ePaper yourself

Delete template?

Save as template?