iCharger 306B Manual - RC Station CH

More documents

Recommendations

Info

iCharger Synchronous Balance Charger/Discharger 306B REVERSE POLARITY CHECK CONNECTION CONNECTION BREAK DOWN SHORT ERROR BREAK DOWN INPUT VOLTAGE LOW VOLTAGE INPUT VOLTAGE OVER VOLTAGE BALANCE PORT CELL LOW VOL BALANCE PORT CELL HIGH VOL BALANCE PORT NOT CONNECT BATTERY CHECK LOW VOLTAGE BATTERY CHECK OVER VOLTAGE Int. TEMP OVER CHG STOPPED Ext. TEMP OVER CHG STOPPED CAPACITY OVER STOPPED SAFETY TIME OUT STOPPED Error messages The output is connected to a battery with incorrect polarity This will be displayed when an interruption of the connection between battery and the charger output has been detected during charging or discharging. A short-circuit at output. Please check the charging leads. The input voltage is below the limit set in the USER SET menu. The input voltage is over the limit (38V). The voltage of one of the cells in the Lithium battery pack is too low. Please check the cell voltages one by one. The voltage of one of the cells in the Lithium battery pack is too high. Please check the cell voltages one by one. In Balance charge mode, no battery is connected to the charger‘s balance port. Without using the balance port, the cell count detected by the charger is less than that set by the user. Please check the cell count of the battery pack. Without using the balance port, the cell count detected by the charger is higher than that set by the user. Please check the cell count of the battery pack. The internal temperature is over 60℃(140 oF). Cool down the unit. The external temperature sensor detects (battery) temperature above the limit. The capacity (mAh) charged or discharged reached the configured protection limit. The charge or discharge time reached the configured protection limit. -28-
iCharger Synchronous Balance Charger/Discharger 306B USB port interpretation Install USB driver This release of the USB driver is contained on the iCharger 306B software CD-ROM. To install the USB driver, run the program X:\USB driver\iChargerUSBInstaller.exe (where X is the drive letter designator for your CD-ROM drive.) Charger firmware upgrade steps Install the iCharger USB driver Run the program X:\Upgrader\Upgrader.exe (you can download the Upgrader.exe software from the following website: http://www.jun-si.com/UploadFiles/Upgrader.rar ). Connect the iCharger to the PC using the supplied USB cable, choose ―Device‖ in ―Device List‖, then select the upgrade file (you can download the latest file). The progress bar will appear after you click ―Update…‖ Note: You must only ever use the supplied USB cable provided with your iCharger as this is a custom cable with internal differences from other USB cables. -29-
Page 2 and 3: iCharger Synchronous Balance Charge
Page 26 and 27: Batt type stop iCharger Synchronous
Page 32: iCharger Synchronous Balance Charge

iCharger 306B Manual - RC Station CH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?