Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Keys<br />
Unlocking<br />
Press the Unlock button on the key fob<br />
to unlock the doors and disarm the<br />
alarm.<br />
The turn signals flash twice and the red alarm<br />
indicator on the console extinguishes.<br />
Note: If neither door or trunk are opened<br />
within one minute, the doors will<br />
automatically re-lock and the alarm will arm.<br />
Programmable button<br />
This button can be programmed to<br />
perform one of the following functions:<br />
• Alarm<br />
The horn sounds and the exterior lights<br />
flash for one minute. Press again to cancel<br />
the alarm.<br />
• Trunk release<br />
Opens the trunk.<br />
• Open or close a HomeLink® device<br />
Operates devices such as a garage door<br />
or gate.<br />
To program this button, use the Touch<br />
Screen. Refer to the Touch Screen Users<br />
<strong>Manual</strong>, provided in your owners package.<br />
To activate the programmed function, press<br />
and hold the button for two seconds.<br />
Replacing the key fob’s battery<br />
The key fob’s battery should last for<br />
approximately one year depending on use.<br />
When the battery needs replacing, you’ll<br />
TR0156<br />
notice a deterioration in performance. For<br />
example, you’ll gradually need to be closer to<br />
the vehicle to operate the key fob.<br />
To replace the battery:<br />
1. Remove the securing screw on the rear of<br />
the key fob and carefully separate the two<br />
halves. Avoid damaging the seal between<br />
the two halves.<br />
2. Remove the batteries, taking care to<br />
avoid touching the circuit board or the<br />
contact surfaces of the battery holder.<br />
3. Fit two new batteries (type CR1616) with<br />
the ‘+’ sides facing upwards.<br />
If possible, avoid touching the flat<br />
surfaces of the battery because finger<br />
marks will reduce battery life. Wipe the<br />
battery clean before fitting.<br />
4. Assemble the two halves of the key fob.<br />
Compliance<br />
The key fob complies with Title 47 CFR Part<br />
15 Subpart C rules for intentional radiators.<br />
Operation is subject to the following<br />
conditions:<br />
• This device may not cause harmful<br />
interference.<br />
• This device must accept any interference<br />
received, including interference that may<br />
cause undesired operation.<br />
Any changes or modifications to the key fob<br />
not expressly approved by the manufacturer<br />
or Tesla Motors could void the user’s<br />
authority to operate the equipment.<br />
Transmitter FCC ID: L2M001004<br />
Doors, locks, and security<br />
4-3