Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Commissioning<br />
Turnbuckle on Boat<br />
Slide torque tube assembly onto foil and clamp just<br />
below top of feeder gap as shown. Use halyard to lift<br />
foil assembly.<br />
CAUTION! Foils can drop suddenly causing injury<br />
to hands. Make sure drum assembly and foils are<br />
securely lifted using a halyard before adjusting<br />
turnbuckle.<br />
Adjust turnbuckle<br />
Check to make sure there is a 1/16"–1/8" (2–4 mm)<br />
gap between deck flange and tack swivel. If necessary<br />
loosen adjusting nut below and take up on turnbuckle to<br />
increase gap between deck flange and tack swivel when<br />
the turnbuckle is tightened.<br />
Reassemble Torque Tube Assembly to Hub Assembly.<br />
Do not use Loctite ® on screws.<br />
Tip: If it is hard to capture posts in cap, push against<br />
stay to help align universal. If necessary loosen<br />
backstay.<br />
Lift foils so top is 1/2"–3/8" (12 mm–16 mm) below<br />
upper terminal.<br />
Slide foil clamp into foil notches and tighten screws<br />
to secure.<br />
Check to make sure<br />
there is a 1 /16" - 1 /8"<br />
(2 - 4mm) gap<br />
34 MKIV Underdeck <strong>Unit</strong> 1, 2, 3
Change language