Form 5a - ICP Forests

In forms PAC, PPS, AQP and AQA passive sampler data (PPS and AQP) and hourly
continuous analyzer data (PAC and AQA) measured at Intensive Monitoring Plots
[IMP] are reported. Besides measurements taken at IMPs, passive samplers can also be
co-located with continuous analyzers at Air Quality Stations [AQ_ST] (e.g. regional or
EMEP Air Quality Stations, but not IMP) for quality control. In this case, for each of
the exposure periods of the passive samplers (typically 2-weeks), both the measured
value and its corresponding mean value measured with continuous analyzers for the
same period have to be reported under form COL. If there are IMP with continuous
analyzers and passive samplers measuring in parallel, then, both forms PAC, PPS, AQP
and AQA, and COL as well have to be filled. In form COL, AQ_STs are identified with
an S before the number (e.g. S004), while IMPs are identified only with plot numbers
(e.g. 102).
(92) Sampler ID
(Air Quality)
For continuous analyzers: If for a given pollutant and plot measurements are taken with
more than one continuous analyzer, identify them with a different sampler_ID (e.g. with
succesive numbers: 01, 02, 03, ...)
For passive samplers: If for a given pollutant and plot, measurements are taken using
several passive samplers (replicates), identify them with a different sampler_ID (e.g.
with succesive numbers: 01, 02,03, ...)
(93) Passive sampler manufacturer
(Air Quality)
Passive sampler manufacturer
CEAM with shelter 01
CEAM without shelter 02
Gradko with shelter 03
Gradko without shelter 04
Gradko combined SO2/NO2 with shelter 05
Gradko combined SO2/NO2 without shelter 06
IVL with shelter 07
IVL without shelter 08
Ogawa with shelter 09
Ogawa without shelter 10
Passam with shelter 11
Passam without shelter 12
Others with shelter (specify in "Observations") 13
Code
Others without shelter (specify in
"Observations") 14
Page 116 / 151